You are here

Basic Electric Guitar Circuits 3: Switches & Output Jacks

Published d

Part 3: Switches and Output Jacks

In Part 1, we discussed how pickups work. In Part 2, we discussed how potentiometers and capacitors work. Now let's take a look at how pickup selector switches and output jacks work.

Pickup Selector Switches

Most guitars have more than one pickup and each one has unique tonal characteristics depending on its placement, construction and materials. The pickup selector switch allows the guitar player to choose between different pickups or a combination of them. The pickup placed close to the guitar neck has a warm, smooth tone with more bass content and is frequently referred to as the "rhythm" pickup, while the pickup placed close to the bridge has a sharper, biting sound with more treble content and is frequently referred to as the "lead" pickup. Of course, these are just generalizations. You might find that the neck pickup sounds sweeter for your leads or maybe you get more rhythm crunch from the bridge pickup. The subjective nature of tone is one of the main reasons it's empowering to be able to customize your own instrument.
People are often confused by the switch terminology of "poles" and "throws", but it's actually quite simple. The switch allows us to change the electrical continuity between its terminals. The "pole" is the name of the terminal whose continuity is switched between one or more throws. As shown in the DPDT (double pole double throw) switch drawing above, in position "1" there is continuity between "Pole A" and "A Throw (1)". In position "2" there is continuity between "Pole A" and "A Throw (2)". This A-side alone could be thought of as an SPDT switch because it has a single pole with two throws, but because we have an additional B-side the entire switch has two poles with each pole having its two respective throws (i.e. DPDT). The standard Telecaster switch could be considered DP3T because it has two poles with each one having three throw terminals. The standard modern Stratocaster switch adds two intermediate switch positions "2" and "4" (as shown below) where each pole has electrical continuity with two of its respective throw terminals at once.
The standard Les Paul switch is shown below. In position "1" P(A) has continuity with T(A), but P(B) is disconnected from T(B). In position "2" both P(A) and P(B) have continuity with their respective throws T(A) and T(B). In position "3" P(B) has continuity with T(B), but P(A) is disconnected from T(A). The ground terminal is used to connect to the common ground along with the potentiometers, output jack and the bridge in order to eliminate popping and buzzing noises.

The Output Jack

The output jack allows us to connect the signal from the guitar to an amplifier. The standard guitar output uses a ¼" mono jack having two terminals (as shown below) which make contact with the mono ¼" plug end of the guitar cable. The "tip" terminal is connected to the output signal and the "sleeve" terminal is connected to the guitar's common ground. This is standard for amps and effects pedals too.

Wiring Diagrams

It's easy to find electric guitar wiring diagrams on-line through the websites of guitar and pickup manufacturers. There are also a lot of popular modifications out there that you might like to try out. Once you understand the basics of how these circuits work, you can even get creative and customize an original circuit that suits your style best. You won't have to feel locked into your standard set up ever again. If you come across a new trick that you think you might like, heat up your soldering iron and try it out.
Amplified Parts - based in Tempe, AZ. Kurt began playing guitar at the age of nine in Kalamazoo, Michigan. He is a guitar DIY'er and tube amplifier designer who enjoys helping other musicians along in the endless pursuit of tone.