Tubes for the Gibson GA 9

Tubes for the Gibson GA 9

The Gibson GA 9 amplifier requires the following components:

× 1
5Y3
5Y3
Solid State Rectifier - Yellow Jacket® YJR, For 5AR4, 5U4, 5Y3
Vacuum Tube - 5Y3GT, Rectifier, Full Wave
Vacuum Tube - 5Y3GT, Sovtek
Solid State Rectifier - For 5AR4, 5U4, 5Y3 Tubes
Vacuum Tube - 5Y3 S, JJ Electronics, Rectifier
Please make a selection above.
The YJR is a direct plug-in replacement adapter for use in most amplifiers that use 5AR4/GZ34, 5U4, 5Y3 or similar full-wave rectifier tubes. The YJR converts your amp's vacuum tube rectifier to a solid state rectifier, reducing tube sag for a tighter sound and feel. The tube rectifier can easily be swapped back in when sag is desired. This Yellow Jacket® is a solid state device and as such does not come with vacuum tubes.
  • Converts most audio amplifiers which use a vacuum tube rectifier 5AR4/GZ34, 5U4 or 5Y3 to a solid state device.
  • Safe for all common amplifiers and transformers.
All Yellow Jacket® converters have a one year warranty against manufacturer defects.
Filamentary twin-diode designed for full-wave rectifier operation in power supplies that have d-c output current requirements up to approximately 125 milliamperes.

Octal rectifier tube (Max DC output current = 125 mA) An indirectly heated diode intended for rectification of commercial-frequency alternating current. It has a 140 mA maximum output and filament voltage of 5 V and a filament current of 2 A ± 0.2 mA.

Solid State Rectifier Direct plug-in replacement for 5AR4, 5U4 and 5Y3 rectifier vacuum tubes in amplifiers with center tapped secondary power transformer. Use when less 'sag' is desired in the power supply; just switch back to the tube rectifier when 'sag' is desired.

The JJ Electronic 5Y3S is a ruggedly built octal rectifier tube with a directly heated cathode. This tube’s solid construction and thick glass envelope offer high reliability. The JJ 5Y3S will work in any 5Y3 position.

$14.95 × 1
$29.45 × 1
$17.50 × 1
$9.95 × 1
$16.95 × 1
× 1
6SJ7
6SJ7
Please make a selection above.
× 2
6V6
6V6
Vacuum Tube - 6V6GT, Mullard Reissue - Matched Pair
Vacuum Tube - 6V6GT / CV-511, Genalex Gold Lion - Matched Pair
Vacuum Tube - 6V6, JJ Electronics - Apex Matched Pair
Vacuum Tube - 6V6GT, Tung-Sol Reissue - Apex Matched Pair
Vacuum Tube - 6V6GT, Electro-Harmonix - Apex Matched Pair
Vacuum Tube - 6V6, JJ Electronics - Apex Burned-In Matched Pair
Vacuum Tube - 6V6, JJ Electronics
Vacuum Tube - 6V6-SD-M, Groove Tubes, Matched Pair
Vacuum Tube - 6V6GT, Electro-Harmonix
Vacuum Tube - 6V6GT, Tung-Sol Reissue
Vacuum Tube - 6V6GT, Mullard Reissue
Vacuum Tube - 6V6GT / CV-511, Genalex Gold Lion
Please make a selection above.

Mullard 6V6GT tube. Made in Russia. This valve is built to stand the high voltages encountered in the Fender Deluxe Reverb and other guitar amplifiers that ran the valves above the published specification. The smooth and balanced frequency response also makes it suitable for hi-fi use.

Genalex Gold Lion 6V6GT / CV511 beam-power tube. Made in Russia.

This 6V6 has the standard rugged construction we’ve come to expect from JJ which allows it handle much higher plate voltages than the typical 6V6 tube. The JJ 6V6 can even be used in place of a 6L6 in some amplifiers. Overall this tube has a warm and balanced tone with incredible separation and response. These tubes can cover a spectrum of sounds and styles all within the same amplifier.

Totally Tweed! The preferred OEM tube of '50s-era Fender Tweed Champ and Deluxe amplifiers The Tungsol 6V6 has a geometry designed to safely handle the higher voltages used in guitar amps " plus heavier plate and grid materials. The result.. better mids and bottom while keeping the smooth top of the classic 6V6's. The Tungsol 6V6 breaks up evenly from low E to high up the neck. Blues players will LOVE these tubes for the way they sing!

Octal power tube (Max Plate Watts = 14W) Beam power tetrode with a specially developed cathode coating, careful alignment of the grid, tri-alloy plate material for flawless performance up to 475 volts. Perfect for high plate voltage amplifiers like the Fender Deluxe Reverb.

This 6V6 has the standard rugged construction we’ve come to expect from JJ which allows it handle much higher plate voltages than the typical 6V6 tube. The JJ 6V6 can even be used in place of a 6L6 in some amplifiers. Overall this tube has a warm and balanced tone with incredible separation and response. These tubes can cover a spectrum of sounds and styles all within the same amplifier.

This 6V6 has the standard rugged construction we’ve come to expect from JJ which allows it handle much higher plate voltages than the typical 6V6 tube. The JJ 6V6 can even be used in place of a 6L6 in some amplifiers. Overall this tube has a warm and balanced tone with incredible separation and response. These tubes can cover a spectrum of sounds and styles all within the same amplifier.

The 6V6 is a low-output power tube (12-18 watts) often used in Fender® amplifiers, including the Champ®, Deluxe™, Dual Professional, Vibro-King®, Princeton®, Vibrolux® and others. It has a very warm, round and soft response with rich harmonics, and distorts easily. One of the best choices ever produced for rehearsal and recording amplifiers. Our most premium design, for long life and professional performance. The choice for many pro players who use Groove Tubes in their favorite amps for recording and rehearsal; fully captures the spirit and sound of tube amps from the '50s and '60s to the present.

Octal power tube (Max Plate Watts = 14W) Beam power tetrode with a specially developed cathode coating, careful alignment of the grid, tri-alloy plate material for flawless performance up to 475 volts. Perfect for high plate voltage amplifiers like the Fender Deluxe Reverb.

Totally Tweed! The preferred OEM tube of '50s-era Fender Tweed Champ and Deluxe amplifiers The Tungsol 6V6 has a geometry designed to safely handle the higher voltages used in guitar amps " plus heavier plate and grid materials. The result.. better mids and bottom while keeping the smooth top of the classic 6V6's. The Tungsol 6V6 breaks up evenly from low E to high up the neck. Blues players will LOVE these tubes for the way they sing!

Mullard 6V6GT tube. Made in Russia. This valve is built to stand the high voltages encountered in the Fender Deluxe Reverb and other guitar amplifiers that ran the valves above the published specification. The smooth and balanced frequency response also makes it suitable for hi-fi use.

Genalex Gold Lion 6V6GT / CV511 beam-power tube. Made in Russia.

$59.00 × 1
$69.90 × 1
$36.30 × 1
$60.00 × 1
$42.90 × 1
$38.80 × 1
$16.65 × 2
$54.95 × 1
$19.95 × 2
$28.50 × 2
$28.50 × 2
$33.95 × 2
Total price for all components:
$0.00
Currently selected components:
5Y3:Not selected
6SJ7:Not selected
6V6:Not selected