Pure Oil Corp. 5D25WG-502
Model: | 5D25WG-502 |
Manufacturer: | Pure Oil Corp. |
Schematics Content
Page 1:
Models 5D15WG-501 and 5025WG-502
Models 5D15WG-501 and 5D25WG-502 are similar to models 5D15WG-501X and 5D25WG-502X with the above exception
Tuning Frequency Range ... 540 to 1600 KC
Power Consumption ... 30 watts (At 117 volts AC)
Power Output ... 1.5 watt maximum, .9 watt (10% harmonics)
Page 2:
Parts List
Note A - Set dial pointer to 1400 KC Index line on dial light diffuser
Dial Calibration
In order to align the receiver, the dial pointer must be positioned on the dial string correctly with reference to the dial. Index lines are provided on the dial light diffuser for this purpose.
Before aligning the receiver (or when replacing the dial light diffuser) check the position of the diffuser strip, making certain that the two extreme index lines are aligned with the inner edges of the diffuser mounting bracket opening. The bracket should be crimped to prevent movement of the diffuser strip. To position the dial pointer, turn the large drive pulley to the maximum counterclockwise position. The dial pointer should be directly over the dial pointer index line. (See illustration).
Drive Cord Replacement
Turn the large drive pulley to the maximum counterclockwise position. Use a new 53 inch drive cord, tie one end to the tension spring and fasten the other end of the spring to the drive pulley. Install the cord as shown in the illustration. Wind 2 3/4 turns counterclockwise around the tuning shaft with the turns progressing away from the chassis. After string is in
Selectivity ... 55 KC Broad at 1000 Times Signal
Intermediate Frequency ... 455 KC
Speaker ... 5" PM Dynamic
Sensitivity (for .05 watt output) ... 25 microvolts average
NOTICE: There is a power rating label on the chassis. This label specifies the power supply on which the radio may be used, and identifies the radio as to chassis, dial and issue letter. When ordering parts or writing, give ALL information appearing on this label.