P.R. Mallory & Co. Elkon Auto B
Model: | Elkon Auto B |
Manufacturer: | P.R. Mallory & Co. (Elkon) |
Schematic Pages
Schematics Content
Page 1:
Connect "A" Hot of Radio Sat to Relay
Connect "A" Hot of Radio Set to Relay Use Regular "C" Batteries
Connect "A". Hot (from Speaker) to Relay Use Regular "C" Batteries
Connect Black Wire from Radio Set to Relay
Connect White Wire to Relay - Black to Grounded Battery Post
Connect No. 14 Wire from "B" to Relay. Preferably Shielded
Coppect "A" Hot of Radio Set to "A"
Choke. "A" Choke to Relay Use Regular C "and" D " Batteries
Connect Yellow Wire to Relay. Black Wire to Grounded Battery Post
Connect Black and Red Wire to Relay
Connect "A" Hot of Radio Set to "A" Choke. "A" Choke to Relay
Connect Red Wire to Relay, Black Wire to Grounded Battery Post
Connect White Wire to Relay. Black Wire to Grounded Battery Post
Connect "A" Hot of Radto Set to Relay
Connect Two 8 MFD. 275 Volt Eikon Condensers Across the Output (B - to B +)
Connect Red Wire to Relay
Connect White Wire to Relay - Black Wire to Grounded Battery Post
Connect Black and Yellow Wire from Radio Set to "A" Choke. "A" Choke to Retay
Connect Black White Wire to "A" Choke.
"A" Choke to Relay
* Remove wire leading to "G" terminal. Move wire fastened to " B + " terminal to "G" terminal, making the "G" terminal, Bt. Install resistors as shown.
If shielded "B" cable is used remove the rivet from the right end of the terminal strip and replace with screw and nuts. Fasten shield to bolt.