Vacuum Tubes
The first electronic amplification of sound was done with Vacuum Tubes. We have pre-amp, power and rectifier vacuum tubes among other types in New Old Stock from the golden era of American & European manufacturing as well as current production tubes from today.
Miniature sharp cutoff pentode designed for use where only low plate and screen voltages are available. The 6AJ5 is especially suitable for operation at high frequencies.
$6.25
Triode-heptode for use in F.M., AM/FM, A.M, and television receivers.
$8.90
Miniature types used as RF or IF amplifiers especially in high-frequency wide-band applications at frequencies up to 400MHz.
$4.90
Heater-cathode type of tube intended for use in compact, light-weight equipment. Because of its small size, the 6AK6 can be used singly or in push-pull to effect a more compact design of power-line receivers.
$4.90
Triple diode triode for F.M. or FM/AM broadcast receivers and for video and audio signal detection in television receivers.
$14.90
The 6AL5 combines two independent diode units in the 7 pin miniature construction. Its high perveance permits high efficiency in either FM or AM detector service.
$4.90
The 6AL7GT is an electron-ray indicator designed especially for use in AM-FM receivers. Through its use, precise tuning of either FM or AM signals is easily accomplished without the use of additional tubes or circuit components.
$6.90
Medium mu triode and a sharp cutoff pentode. The pentode section may be used as an IF amplifier or a reactance tube; the triode section is well suited for use in low-frequency-oscillator, sync clipper, sync separator, and phase splitter circuits.
$15.90
Miniature beam-power pentode designed for use in the audio-frequency power output stage of television and radio receivers. It may also be used as a triode-connected vertical deflection amplifier in television receivers.
$9.90
Miniature double diode high mu triode designed for service as a combined first audio amplifier, detector, and AVC tube in radio receivers. However, the 6AQ6 employs a 150 mA heter.
$3.90
Electro-Harmonix 6AQ8 dual triode preamp tube. Made in Russia.
$46.60
Pentode power amplifier using the miniature construction. It is intended for service in AC and storage battery operated receivers where moderate power sensitivity and power output is desired.
$9.90
Beam power amplifier designed specifically for applications requiring relatively high peak plate currents at negative grid potentials. It is constructed to withstand relatively high plate potentials.
$17.75
High current, twin power triode widely used in electronically regulated power supplies. The high perveance of this tube permits it to pass large currents at low plate voltages, thus providing for efficient series regulation. Except for the use of a T-12 glass envelope, the 6AS7GA is identical to the 6AS7G.
$11.90
High current, twin power triode widely used in electronically regulated power supplies. The high perveance of this tube permits it to pass large currents at low plate voltages, thus providing for efficient series regulation. Shouldered glass (ST-16) envelope.
$27.90
Miniature, duplex-diode, high-mu triode designed for use as a combined detector, amplifier, and automatic-volume-control tube
$3.90
Miniature sharp cutoff pentode primarily designed for use as a high-gain radio-frequency or intermediate-frequency amplifier. Its low grid-plate capacitance and high transconductance make it especially suited for high-frequency wide-band applications
$7.90
Beam pentode designed, primarily for use as the horizontal-deflection amplifier in television receivers. The tube exhibits high perveance, high plate current at low plate and screen voltages, and a high ratio of plate to screen current
$7.90
Miniature duplex-diode, high-mu triode intended primarily for use as a combined detector, amplifier, and automatic-volume-control tube in radio receivers. The triode section incorporates a high amplification factor
$5.90
Compactron containing three medium-mu triodes suitable for general-purpose amplifier, phase inverter, or oscillator applications.
$9.85
Miniature tube containing a high-mu triode and a sharp-cutoff pentode. The triode section is intended for service as a sync separator and the pentode section as a video amplifier.
$4.90
Full-wave rectifier of the heater-cathode type intended for use in AC operated and automobile receivers. Because of its heater-cathode construction it has the same heating time as that of other heater-cathode types in the receiver.
$5.90
Medium mu triode and a semi-remote cutoff pentode in the 9 pin miniature construction. It is intended for general purpose applications in both monochrome and color television receivers.
$12.90