Vacuum Tubes

The first electronic amplification of sound was done with Vacuum Tubes. We have pre-amp, power and rectifier vacuum tubes among other types in New Old Stock from the golden era of American & European manufacturing as well as current production tubes from today.
T-6AQ5A_6HG5 Vacuum Tube - 6AQ5A / 6HG5, Tetrode, Beam Power
Miniature beam-power pentode designed for use in the audio-frequency power output stage of television and radio receivers. It may also be used as a triode-connected vertical deflection amplifier in television receivers.
T-12AX7S-MG-JJ Vacuum Tube - 12AX7S, JJ Electronics, Mid Gain
A new take on the classic 12AX7 preamp tube. While it uses the same rugged build and thick glass as other JJ preamp tubes, this tube differs in construction from the typical 12AX7 in that it features a medium-long plate, which provides a dynamic and open sound with a rich forward sounding mid range. This tube offers low noise and low microphonics.
T-6L6WXT+SOVT Vacuum Tube - 6L6WXT+, Sovtek
Higher in gain than the 5881WXT, with full base.
Sovtek is proud to announce the release of their new 6L6WXT+ vacuum tube. Modelled after the vintage RCA 6L6GC "blackplate," the Sovtek 6L6WXT+ features larger plate dimensions and improved grid structure for increased power handling capabilities. The 6L6WXT+ also features mica spacers with metal springs to eliminate tube rattle and microphonics. The Sovtek 6L6WXT+ yields a 20% higher output than the Sovtek 5881WXT and offers superior tone and overall performance to any 6L6 or KT66.
Starting at $22.50
T-6550-TUNG Vacuum Tube - 6550, Tung-Sol Reissue
Copy of the original type 3 Tung-Sol 6550 made in the 1960s. Triple getter, carbonized screen, and gold plated grid. The current production benchmark of the classic 6550.
Made in Saratov, Russia
Starting at $34.95
T-6BE6_EK90 Vacuum Tube - 6BE6 / EK90, Heptode
Miniature heptode primarily designed to perform the combined functions of the mixer and oscillator in superheterodyne circuits in both the standard broadcast and FM bands.
T-6L6GC-M-STR-X Vacuum Tube - 6L6GC-M-STR, Ruby Tubes
Octal power tube (Max Plate Watts = 30W)
Starting at $18.25
T-6AV6_EBC91 Vacuum Tube - 6AV6 / EBC91, Dual Diode, Triode
Miniature duplex-diode, high-mu triode intended primarily for use as a combined detector, amplifier, and automatic-volume-control tube in radio receivers. The triode section incorporates a high amplification factor
T-6X4_EZ90 Vacuum Tube - 6X4 / EZ90, Rectifier, Full Wave
Miniature heater-cathode type twin diode designed for full-wave rectifier operation in compact power supplies. The tube is intended for service in automobile and a-c radio receivers.
T-12SK7 Vacuum Tube - 12SK7, Pentode, Remote Cut-Off
The T-12SK7 is the same as the 6SK7 except for heater ratings.
T-35L6GT Vacuum Tube - 35L6GT, Beam Power Amplifier
Beam pentode primarily designed for use in the audio frequency power output stage of radio receivers. Features include high power sensitivity and high efficiency at relatively low plate and screen voltages.
T-6AL5_6EB5 Vacuum Tube - 6AL5 / 6EB5, Dual Diode
The 6AL5 combines two independent diode units in the 7 pin miniature construction. Its high perveance permits high efficiency in either FM or AM detector service.
T-6K6GT Vacuum Tube - 6K6GT, Pentode, Power Amplifier
The 6K6GT is an indirectly heated cathode type power amplifier pentode designed for service in the output stages of AC, AC/DC and storage battery operated receivers.
T-EL84-EH Vacuum Tube - EL84, Electro-Harmonix
Tube measurements are as follows:
  • Height: 2.75” (without pins)*
  • Diameter: 0.87” *

*Note: Due to the method of production in regards to the glass, measurements may vary slightly.
Starting at $11.70
T-6AN8A Vacuum Tube - 6AN8A, Triode, Pentode
Medium mu triode and a sharp cutoff pentode. The pentode section may be used as an IF amplifier or a reactance tube; the triode section is well suited for use in low-frequency-oscillator, sync clipper, sync separator, and phase splitter circuits.
T-6X5GT_EZ35 Vacuum Tube - 6X5GT / EZ35, Rectifier, Full Wave
Cathode type rectifier designed particularly for use in automobile receivers.
T-6L6GE-MP-GT Vacuum Tube - 6L6 GE Reissue, Groove Tubes, Matched Pair
Octal power tube (Max Plate Watts = 30W)
EXCLUSIVE GT design. The GE is a faithful reproduction of the original "clear top" 6L6. The flagship of the GT 6L6 line, it looks and sounds exactly like the original G.E. tube used by Fender® in the '50s and '60s. It took more than four years to develop, and has stunning
clarity and power.
T-6SL7GT-SOVT Vacuum Tube - 6SL7GT, Sovtek
Sovtek 6SL7GT
T-6V6GT-CHINA Vacuum Tube - 6V6GT, Chinese
Chinese 6V6GT Available in Singles, Matched Pairs or Matched Quads - please select from list.
Starting at $13.02
T-6SJ7 Vacuum Tube - 6SJ7, Pentode, Sharp Cut-Off
Metal sharp-cutoff pentode designed for use as a biased detector or high-gain amplifier.
T-12SA7 Vacuum Tube - 12SA7, Heptode
Pentagrid converter designed to minimize frequency drift. They are intended for service as combined oscillators and mixers in AC, storage battery, and AC/DC operated superheterodynes.
T-7591A-EH-X Vacuum Tube - 7591A, Electro-Harmonix
7591A Electro-Harmonix Power Tube Beam power tetrode used in vintage Ampeg and Gibson guitar amplifiers. Also, used in tube hi-fi equipment made by Fisher, Scott, and Harmon-Kardon.
Starting at $22.95
T-6SK7 Vacuum Tube - 6SK7, Pentode, Remote Cut-Off, RF
Remote-cutoff pentode. It is designed for use as a high-gain radio-frequency or intermediate-frequency amplifier in a radio receiver.
T-1T4_DF91 Vacuum Tube - 1T4 / DF91, Pentode, Remote Cut-Off
Miniature remote-cutoff pentode designed for use as a radio-frequency or intermediate frequency amplifier in compact, battery-operated equipment.
T-1U4 Vacuum Tube - 1U4, Pentode
Miniature, filamentary, sharp-cutoff pentode intended for radio frequency or intermediate frequency amplifier use in battery-operated receivers.
Don't see what you're looking for? Send us your product suggestions!