Click each question to see its answers.
"Am I going to need bushings to use these in my neck? Are these 1/4" shafts?
Asked by Anonymous on September 30th, 2015.
These are 1/4" shafts. You may need adapter bushings when using this product with necks drilled for modern tuning machines. The part number for the adapter bushings is P-GT105.
Can I use these on an American Standard Stratocaster?
Asked by Anonymous on October 20th, 2016.
Hi, most American Standard strats have a 10mm or modern tuner hole size. These tuners are vintage spec and are smaller than 10mm. You would need to order conversion bushings to makes these work with your strat.
Will these fit a Peavey Reactor?
Asked by Anonymous on November 2nd, 2016.
If your guitar uses vintage style tuners with a press fit bushing then these will work. If it has modern style threaded bushing then you may need conversion bushings.
Would these be any better then the vintage tuners that came on my squire classic vibe tele or basically the same tuners?
Asked by Anonymous on September 8th, 2017.
The first thing you will need to determine is if your guitar is reamed for a modern 10mm tuner or is vintage spec as these are vintage spec tuners. You can always contact us directly to help you find the right part at: 480-296-0890 or email@example.com.
What is the ratio?
Asked by Anonymous on February 6th, 2018.
Unfortunately Fender has not published the tuning ratio on these tuners.
Do these have the shaft into which the end of the string goes?
Asked by Anonymous on March 28th, 2018.
Yes these are vintage style tuners where the string is fed down the tuner rather than through a hole in the sid of the tuner.
Are these made in America or Japan?
Asked by Anonymous on April 17th, 2018.
Currently these are made in Japan.
what is the hole size for ferrel?
Asked by Anonymous on December 26th, 2019.
These require an 11/32" (8.73mm) diameter hole in the headstock for a proper fit.