Transistor - Peavey, 2N5462, P-Channel Amp, TO-92 Case

Item Unavailable

Sorry! You are trying to check out one of our items which is no longer available. Why not check out one of these alternate options?

P-QMJ15016 Transistor - MJ15016, PNP, Complementary High-Power
Transistor MJ15016, TO-3 Case, PNP
PowerBase complementary transistors designed for high power audio, stepping motor and other linear applications. These devices can also be used in power switching circuits such as relay or solenoid drivers, dc–to–dc converters, inverters, or for inductive loads requiring higher safe operating areas.
Safe Operating Area - Rated to 60V
$2.85
P-QSJ81180 Transistor - Peavey, NPN 140V Driver, SJ-81180, 180V, 1A
SJ-81180, NPN driver, 180V, 1A, TO-3 Case.
$8.25
P-QSJE5331 Transistor - Peavey, SJE 5331, 120V, 3A
SJE 5331, 120V, 3A, Case-77.
$1.50
P-QSJE5332 Transistor - Peavey, SJE 5332, 120V, 3A
SJE 5332, 120V, 3A, Case-77.
$1.65
P-QMPS6531 Transistor - Peavey, MPS 6531, NPN Amplifier, 40V, TO-92
MPS 6531, NPN general purpose amp, 40V, TO-92 Case.
$2.00
P-Q2N3055 Transistor - 2N3055, High Power NPN Silicon, TO-3 Case
15 A, 60 V, 115 W
EPIBASE - Designed for power amplifier and switching regulator applications. The best choice where high frequency response, low switching losses and good safe operating area are required.
  • Current Gain - Bandwidth Product - fT = 2.5 MHz (Min) @ Ic = 1.0 Adc
  • Safe Operating Area - Full Power Rating to 40 V
$2.25
On Backorder
P-QQ4025P Triac - Q6025P5 - Alternistor, 400V, 25A, Fastpack TO-3 Base
Alternistors are specifically designed for applications which are required to switch highly inductive loads. To accomplish this, a special chip has been designed which effectively offers the same performance as two thyristors (SCRs) wired inverse parallel (back to back); hence the alternistor has better turn-off behavior than a standard triac.
$14.95
P-QSJE2153 Transistor - Peavey, PNP Darlington, SJE 2153, 80V, 3A
SJE 2153 (TIP107), PNP Darlington, 80V, 3A, TO-3 Case.
$1.95
P-QMPS6533 Transistor - Peavey, MPS 6533, PNP Amplifier, 40V, TO-92
MPS 6533, PNP general purpose amp, 40V, TO-92 Case.
$2.00
P-QMJ15023 Transistor - MJ15023, PNP, Power Transistor
Transistor MJ15023, TO-3 Case, PNP
PowerBase power transistors designed for high power audio, disk head positioners and other linear applications.
Features
  • High Safe Operating Area (100% Tested) −2 A @ 80 V
  • High DC Current Gain − hFE = 15 (Min) @ IC = 8 Adc
$6.00
P-QLM386N1 Integrated Circuit - LM386N-1 / NOPB
LM386 Low Voltage Audio Power Amplifier The LM386 is a mono low voltage amplifier that can be used in a variety of applications. It can drive loads from 4 Ω to 32 Ω. The gain is internally set to 20 but it can be modified from 20 to 200 by placing a resistor and capacitor between pins 1 and 8. As this is an Op Amp it can be used in different configurations to fit in several applications. The internal gain setting resistor allows the LM386 to be used in a very low part count system. In addition a series resistor can be placed between pins 1 and 5 to modify the gain and frequency response for specific applications. These are found in many small audio amplifiers and even tiny pedal sized guitar amplifiers! There are tons of possibilities for this little Op Amp.
$1.25
R-VOP1020 Switch - Vibrato LDR, for Fender® Amps
Optocoupler. Vibrato LDR for Fender Amps.
Fix the dead LDR style tremolo on your vintage Fender amps as well as others.
  • Non- polarized optical side is indicated by silver dot and slightly longer leads
  • Resistive side is indicated only by slightly shorter leads

This information can also be found within the diagram located in the Specifications, Files, and Documents section on this page.
$8.95
R-VTL5C1 Optocoupler - VTL5C1, Vactrol, for Channel Switching
VTL5C1 vactrols for use in amplifiers, effect pedals, synthesizers and more. The VTL5C1 was commonly used for channel switching circuits in amps made by Crate and others.
$7.95
P-QNE5532 Integrated Circuit - NE5532, Low-Noise Dual Op-Amp
This a high performance dual low noise operational amplifier. Compared to the standard dual operational amplifiers, such as the NJM1458, it shows better noise performance, improved output drive capability, and considerably higher small-signal and power bandwidths. it is compensated internally for voltage follower circuit. This makes the device especially suitable for application in high quality and professional audio equipment, instrumentation, control circuits, and telephone channel amplifiers
Features:
  • Operating Voltage = ±3V~±22V
  • Small Signal Bandwidth = 10MHz typ.
  • Output Drive Capability = 600Ω,10Vrms typ.
  • Input Noise Voltage = 5nV/√Hz typ.
  • Power Bandwidth = 140kHz typ.
  • Slew Rate = 8V/µs typ.
  • Bipolar Technology
$1.15
P-QBR-34 Rectifier - Single-phase Bridge, 3A 400V
A full wave rectifier with 4 elements in a bridge circuit so that DC voltage is obtained from one pair of junctions when an AC voltage is applied to another pair of junctions.
$0.95
P-QBS170 Transistor - Mosfet BS170, Small Signal
MOSFET BS170 N-Channel Transistor. Used in MOD® Kits.
Note - this is a fragile component! Use caution not to overheat or break leads.
$1.25
P-QTL072 Op-Amp - TL072, low-noise JFET dual operational amplifier
The TL072is a high speed JFET input dual operational amplifier incorporating well matched, high voltage JFET and bipolar transistors in a monolithic integrated circuit. The device features high slew rates, low input bias and offset current, and low offset voltage temperature coefficient.
$0.70
P-QTL074 Integrated Circuit - TL074, Quad Op-Amp
Low noise JFET quad operational amplifier. Incorporates well matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. Features high slew rates, low input bias and offset currents, and low offset voltage temperature coefficients.
Features:
  • Wide common-mode and differential voltage range
  • Low input bias and offset current
  • Low noise en = 15 nV/HZ
  • Output short-circuit protection
  • High input impedance JFET input stage
  • Low harmonic distortion: 0.01%
  • Internal frequency compensation
  • Latch up free operation
  • High slew rate: 16 V/us (typical)
$1.15
P-Q1N5408 Diode - standard recovery rectifier, 3A, 1000V, 1N5408
1N5408 Diode. Lead mounted standard recovery rectifiers are designed for use in power supplies and other applications having need of a device with the following features:
  • High Current to Small Size
  • High Surge Current Capability
  • Low Forward Voltage Drop
$0.38
Don't see what you're looking for? Send us your product suggestions!