Transformers & Chokes

P-T298DT Transformer - Hammond, Line Step Up Isolation, Toroidal, 500 VA
Capacity: 500 VA
Dimensions: 9" long by 6" wide by 4" height
Features:
  • Primary 120VAC, 50/60 Hz., Secondary 240VAC.
  • Provides circuit isolation.
  • Toroidal transformer for high isolation, low noise, light weight cool operation and low profile.
  • 50 or 60 Hz.
$270.24
P-T1182-40 Transformer- Hammond, Toroidal Power, 40V / 80V secondary
Dual 117/234 VAC primary, 50/60 Hz. operation. 80 V series, 40 V parallel secondary.
$225.18
P-TBFT-1B Transformer - One Electron, BFT-1B, Power
The BFT-1B from One Electron was designed to power a stereo amplifier using UBT-1's in each channel but will also power an 80 watt push-pull tube amplifier. The BFT-1B is slightly larger than earlier versions of the BFT-1, allowing lower flux density and cooler operation. The tapped high-voltage windings and three filament windings provide flexibility in design. An electrostatic shield between the primaries and secondaries reduces power-line noise coupling. The primary arrangements allows use on virtually any power grid in the world.
$225.00
P-TF26477 Transformer - Fender®, Power, for Tone Master
Fender® Original Tone Master Power Transformer. Equivalent to #026477.
$179.95
On Backorder
P-T162XSEA Transformer - Hammond, Output, Single-Ended, 30 W
  • Over designed for single ended tube output circuits (triode, tetrode or pentode tubes).
  • Enclosed (shielded), 4 slot, above chassis Type 'X' mounting.
  • Frequency response at least 20 Hz. to 20 Khz. at full rated power (± 1 db max. ref.
$159.23
P-TM9100O Transformer - Marshall, Output, 100 W, for JCM900
Genuine Marshall™ 100 watt output transformer for JCM900 and JCM2000.
$139.95
P-TM45O Transformer - Marshall, Output, for JTM45
Genuine Marshall™ output transformer for JTM45.
$135.00
P-T176D Transformer - Hammond, Step-Up, 500VA
Capacity: 500VA Features:
  • Single winding does not provide isolation, for use where equipment is already isolated and only voltage change is required.
  • World wide applications, 50 or 60 Hz.
$132.86
P-TUBT-2 Transformer - One Electron, Output, 4800 Ω to 16/8/4 Ω
The UBT-2 from One Electron is the same size and power (15 watts) as the UBT-1, but has a higher primary impedance suitable for single tubes running at B+ voltages of 400 to 500 volts, such as: 50, WE 300B,etc.
$129.95
P-TUBT-1 Transformer - One Electron, Output, 1600 Ω to 16/8/4 Ω
The UBT-1 from One Electron is a low-impedance single-ended output transformer intended for parallel combinations of tubes running a B+ voltages of 250 to 325 volts, such as: two or three EL34s (triode connected), three 2A3s, two 300Bs, two 6AS7s, etc., as well as single sweep tubes run in 'enhanced-triode' mode, resulting in 10 to 15 watts of output power.
$125.00
P-T850-X Transformer - Hammond, Audio Broadcast Quality, 850A Series
Deep-drawn steel case with tin plated finish, with two convenient 6-32 mounting studs with mounting hardware. Sealed case and wax potted core internally for stable characteristics and long life. Wide frequency response +/- 0.5 db max. from 20 Hz. to 20 Khz. (except units over 5K ohms impedance, may be down 1 db @ 20 Khz.) Insertion loss of apx. 1 db.
$120.63
P-TM950O Transformer - Marshall, Output, 50 W, for JCM 900
Genuine Marshall™ output transformer for JCM900 and JCM2000.
$117.80
P-TM950P Transformer - Marshall, Power, 50 W, for JCM 900
Genuine Marshall™ 50 watt power transformer for JCM900.
$115.00
P-T300-Z Transformer - Hammond, High Voltage Universal Plate & Filament, Horizontal mount
  • Primary: Universal - 100, 110, 120, 200, 220,230, 240 VAC 50/60 Hz.
    • NOTE: units are designed to operate with BOTH primary windings engaged.
    • See primary wiring information under resources.
  • Bias Tap: 50 VAC tap from high voltage secondary C.T.
Starting at $111.62
P-TM45P Transformer - Marshall Replacement, Power for JTM45
Replacement power transformer for Marshall JTM45.
$110.00
P-TUBT-3 Transformer - One Electron, Output, 3000 Ω to 16/8/4 Ω
The UBT-3 from One Electron is the same size and power (15 watts) as the UBT-1, but has a primary impedance suitable for single or paralleled tubes running at B+ voltages of 300 to 400 volts, such as: 2A3, WE 300B, 50, etc.
$109.95
P-T800-X Transformer - Hammond, Audio Broadcast Quality, 800A Series
Deep-drawn steel case with tin plated finish, with two convenient 6-32 mounting studs with hardware. Includes wire leads (minimum length of 4"). Frequency response +/- 0.5 db max. from 50 Hz. to 15 Khz. Insertion loss of apx. 1 db. Maximum power level +15 dbm. (except 841A, 842A & 844A which are +20 dbm) with specified characteristics, or higher levels with reduced low frequency performance.
$106.28
P-T143 Transformer - Hammond, Power, 350-0-350V, 70-90 mA
Custom manufactured to replace most 6 and 7 tube sets of the early 1930s. Supplied with vertical mounting shells. Provides a seperate filament winding for audio output stages.
Specifications
Rating: 350-0-350 V, 70 or 90 mA (if 5 V winding is used with 2 A rectifier)
Windings: 5 V, 3 A; 2.5 V, 7.5 A; 2.5 VCT, 3.5 A
Mounting Centers:2 x 2.625"
Weight: 4.2 lbs.
Overall Height: 3.12"
$105.95
P-T1182-24 Transformer- Hammond, Toroidal Power, 24V / 48V secondary
Dual 117/234 VAC primary, 50/60 Hz. operation. 48 V series, 24 V parallel secondary.
Starting at $104.55
P-TM-P100 Transformer - Marshall Replacement, Power, 100 W
100 watt replacement power transformer for Marshall. Good replacement for JMP and JCM800s for EL34! Built to vintage specs with exact interleave ratios and materials. Gives great classic sound. Great for upgrading later issue Marshall amps.
$99.95
P-T1650XA Transformer - Hammond, Tube Output, Easy Wire Secondary
  • Designed for push-pull tube output circuits.
  • Enclosed (shielded), 4 slot, above chassis Type 'X' mounting.
  • Frequency response 30 Hz. to 30 Khz. at full rated power (± 1 db max. - ref.
Starting at $96.51
P-T290-MARSHALL Transformer - Hammond, Guitar Amplifier, replacement for Marshall
  • Replacements for Marshall amps
  • Designed for drop in replacement of original units.
  • Physically, parts were designed to look similar to original factory units (where possible).
  • Material used & design specs. were kept as close as possible to the original part to preserve the stock "tone".
Starting at $96.50
P-TF41752 Transformer - Fender®, Power, Hot Rod Deville
Fender Original Hot Rod DeVille Power Transformer. Equivalent to #041752.
$94.95
On Backorder
P-T1750X-VOX Transformer - Hammond, Output, replacement for Vox
  • Replacements for Vox Amps
  • Designed for drop in replacement of original units.
  • Physically, parts were designed to look similar to original factory units (where possible).
  • Material used & design specs. were kept as close as possible to the original part to preserve the stock "tone".
Starting at $94.10
Don't see what you're looking for? Send us your product suggestions!