Switches

Includes: 3 pole, 4 position rotary switch, ¼" output jack and black chicken head knob. Hammond 1600 series transformers all provide secondary impedances of 4, 8, or 16 ohms but due to the unique wiring of the secondary, the impedance cannot be changed without rewiring... Until now. We now offer a selector switch, pre-wired and complete with ¼" output jack. Follow simple instructions provided to wire transformer secondary to switch, mount switch and ¼" jack in separate 3/8" diameter holes in chassis and you'll easily be able to select output impedance as necessary.

Includes: 3 pole, 3 position rotary switch, ¼" output jack and black chicken head knob. Hammond 1600A series transformers provide 'easy wire secondary' impedances of 4, 8, or 16 ohms. We now offer a selector switch, pre-wired and complete with ¼" output jack. Follow simple instructions provided to wire transformer secondary to switch, mount switch and ¼" jack in separate 3/8" diameter holes in chassis and you'll easily be able to select output impedance as necessary. (Not recommended for 1645A or 1650G) (See P-H1600 for a selector switch to work with Hammond 1600 series transformers.)

Rotary impedance selector. Modern, selects between 4Ω, 8Ω, and 16Ω. Panel mount from front side.

Rotary impedance selector, 4/8/16. Body screws onto chassis hole.

.3A 125 VAC. 1 pole, 12 position, solid ¼" shaft.

.3A 125VAC. 2 pole, 6 position, solid ¼" shaft.

3 pole, 4 position (make before break) rotary switch with a ¼" solid shaft.

Rotary Switch, 3 Poles, 3 Positions (12 solder terminals), Make Before Break. 1/4 solid shaft Bushing width: 11/32" Bushing height: 5/16" Includes nut & washer 0.3A 125VAC

Single pole multi-position, general purpose rotary switch. This switch features a nylon actuator in a metal clad construction along with a self-cleaning silver plated contact design. Typically used in applications requiring multi-position controls.

Vintage style selector switch male part, replacement for Marshall.

High quality three position rotary switch commonly used as an impedance selector switch on tube amps. This rugged switch is rated for 6A at 125VAC and 3A at 250VAC. The flatted 6mm shaft can be used with the shaft adapter found in the accessories below to easily fit standard ¼” knobs. Mounting hardware included.

Cable-mounted inline switch (On-Off) most often used for lamps and other applications. This switch pairs with SPT-1 type power cords and features a thumbwheel actuator.

• Ratings:
  
  • IEC: 6.3 A / 250 VAC; 50 Hz
  • UL: 10 A / 250 VAC; 60 Hz
  • CSA: 8 A / 250 VAC; 60 Hz
• Mounting: Panel Mount from front side
• Fastening: Screw-on mounting
• Terminal: Solder
• Number of Stages: 3
• Lifetime: 300 operating cycles (without load)
• Degree of Protection: IP 40
• Allowable Operation Temp.: -40 °C to 85 °C
• Climatic Category: 25/85/21 acc.