Semiconductors

P-QLM386N1 Integrated Circuit - LM386N-1/NOPB
LM386 Low Voltage Audio Power Amplifier The LM386 is a mono low voltage amplifier that can be used in a variety of applications. It can drive loads from 4 Ω to 32 Ω. The gain is internally set to 20 but it can be modified from 20 to 200 by placing a resistor and capacitor between pins 1 and 8. As this is an Op Amp it can be used in different configurations to fit in several applications. The internal gain setting resistor allows the LM386 to be used in a very low part count system. In addition a series resistor can be placed between pins 1 and 5 to modify the gain and frequency response for specific applications. These are found in many small audio amplifiers and even tiny pedal sized guitar amplifiers! There are tons of possibilities for this little Op Amp.
$1.25
R-VOP1020 Switch - Vibrato LDR, for Fender® Amps
Optocoupler. Vibrato LDR for Fender Amps.
Fix the dead LDR style tremolo on your vintage Fender amps as well as others.
  • Non- polarized optical side is indicated by silver dot and slightly longer leads
  • Resistive side is indicated only by slightly shorter leads

This information can also be found within the diagram located in the Specifications, Files, and Documents section on this page.
$8.95
R-VTL5C1 Optocoupler - Vactec, for Channel Switching
VacTec Vactrol. Opto-isolator with 4 leads. Used in Crate and others.
$7.95
P-QMJE15029 Transistor - Kustom, MJE15029 PNP Bipolar Power
MJE15029 PNP bipolar power transistor (TO-220 package). Designed for use as high-frequency drivers in audio amplifiers.
  • Max collector to emitter voltage = 120 V
  • Max collector to base voltage = 120 V
  • Max emitter to base voltage = 5 V
  • Max collector current (continuous) = 8 A
$0.22
Save 45%
Originally: $0.40
P-QNE5532 Integrated Circuit - NE5532, Low-Noise Dual Op-Amp
This a high performance dual low noise operational amplifier. Compared to the standard dual operational amplifiers, such as the NJM1458, it shows better noise performance, improved output drive capability, and considerably higher small-signal and power bandwidths. it is compensated internally for voltage follower circuit. This makes the device especially suitable for application in high quality and professional audio equipment, instrumentation, control circuits, and telephone channel amplifiers
Features:
  • Operating Voltage = ±3V~±22V
  • Small Signal Bandwidth = 10MHz typ.
  • Output Drive Capability = 600Ω,10Vrms typ.
  • Input Noise Voltage = 5nV/√Hz typ.
  • Power Bandwidth = 140kHz typ.
  • Slew Rate = 8V/µs typ.
  • Bipolar Technology
$1.15
P-QBR-34 Rectifier - Bridge, 3A 400V
A full wave rectifier with 4 elements in a bridge circuit so that DC voltage is obtained from one pair of junctions when an AC voltage is applied to another pair of junctions.
$0.95
P-QBS170 Transistor - Mosfet BS170, Small Signal
MOSFET BS170 N-Channel Transistor. Used in MOD® Kits.
Note - this is a fragile component! Use caution not to overheat or break leads.
$1.25
P-QTL072 Integrated Circuit - TL072, Dual Op-Amp
Integrated Circuit (DIP)
$0.70
P-QTL074 Integrated Circuit - TL074, Quad Op-Amp
Low noise JFET quad operational amplifier. Incorporates well matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. Features high slew rates, low input bias and offset currents, and low offset voltage temperature coefficients.
Features:
  • Wide common-mode and differential voltage range
  • Low input bias and offset current
  • Low noise en = 15 nV/HZ
  • Output short-circuit protection
  • High input impedance JFET input stage
  • Low harmonic distortion: 0.01%
  • Internal frequency compensation
  • Latch up free operation
  • High slew rate: 16 V/us (typical)
$1.15
P-Q1N5408 Diode - 1N5408
1N5408 Diode
  • 1000V
  • 3A
$0.38
P-QMJ15016 Transistor - MJ15016, PNP, Complementary High-Power
Transistor MJ15016, TO-3 Case, PNP
PowerBase complementary transistors designed for high power audio, stepping motor and other linear applications. These devices can also be used in power switching circuits such as relay or solenoid drivers, dc–to–dc converters, inverters, or for inductive loads requiring higher safe operating areas.
Safe Operating Area - Rated to 60V
$2.85
P-Q971 Diode - 1N4148A
A semiconductor device which passes current in the forward direction(from anode to cathode), and blocks current in the opposite direction.
$0.50
P-QM5201 Integrated Circuit - M5201
$4.50
P-Q2N5462 Transistor - Peavey, 2N5462, P-Channel Amp, TO-92 Case
2N5462 (NTE326), P-Channel General Purpose Amp, TO-92 Case.
$1.00
P-Q1N4007 Diode - 1A 1000V
A semiconductor device which passes current in the forward direction(from anode to cathode), and blocks current in the opposite direction.
$0.15
P-QSJ81180 Transistor - Peavey, NPN 140V Driver, SJ-81180, 180V, 1A
SJ-81180, NPN driver, 180V, 1A, TO-3 Case.
$8.25
P-QHFA08 Diode - Hexfred, 8A, 600V
High performance, ultrafast diodes. Improve efficiency, reduce noise, allow higher frequency operation.
$2.75
P-QSJE5331 Transistor - Peavey, SJE 5331, 120V, 3A
SJE 5331, 120V, 3A, Case-77.
$1.50
P-QSJE5332 Transistor - Peavey, SJE 5332, 120V, 3A
SJE 5332, 120V, 3A, Case-77.
$1.65
P-QTDA7293 Integrated Circuit - Marshall, TDA7293 amplifier
120V - 100W DMOS audio amplifier with mute/standby.
$11.95
P-QMPS6531 Transistor - Peavey, MPS 6531, NPN Amplifier, 40V, TO-92
MPS 6531, NPN general purpose amp, 40V, TO-92 Case.
$2.00
P-Q2N3055 Transistor - 2N3055, High Power NPN Silicon, TO-3 Case
15 A, 60 V, 115 W
EPIBASE - Designed for power amplifier and switching regulator applications. The best choice where high frequency response, low switching losses and good safe operating area are required.
  • Current Gain - Bandwidth Product - fT = 2.5 MHz (Min) @ Ic = 1.0 Adc
  • Safe Operating Area - Full Power Rating to 40 V
$2.25
P-QQ4025P Triac - Q4025P - Alternistor, 400V, 25A, Fastpack TO-3 Base
Alternistors are specifically designed for applications which are required to switch highly inductive loads. To accomplish this, a special chip has been designed which effectively offers the same performance as two thyristors (SCRs) wired inverse parallel (back to back); hence the alternistor has better turn-off behavior than a standard triac.
$14.95
Don't see what you're looking for? Send us your product suggestions!