P-QSBS14 Diode Thyristor - Peavey, SBS 14 Bidirectional, 8V, TO-92 Case
Designed for full-wave triggering in Triac phase control circuits, half-wave SCR triggering application and as voltage level detectors. Used in most Peavey linear power amplifier designs through 2000 including CS/M/DECA series power amps, IPA300, and all models using 402/602/304S/204S power modules.
  • Low Switching Voltage — 8 Volts Typical
  • Uniform Characteristics in Each Direction
  • Low On-State Voltage — 1.7 Volts Maximum
  • Low Off-State Current — 0.1 mA Maximum
P-QSJ73180 Transistor - Peavey, PNP 180V Output, SJ-73180, 180V, 3A
SJ-73180 (MJ21193), PNP output, 180V, 3A, TO-3 Case.
P-QA18937 Transistor - Fender®, A18937
A18937 Transistor - Fender
P-QDG212CJ Integrated Circuit - Korg, For Marshall, DG212CJ
Korg IC DG212CJ Used in certain Marshall amplifiers
P-QSDS7204 Transistor - Peavey, SDS 7204, 300V, 10MA
SDS 7204, 300V, 10 mA, Case-30.
P-QSJ81180 Transistor - Peavey, NPN 140V Driver, SJ-81180, 180V, 1A
SJ-81180, NPN driver, 180V, 1A, TO-3 Case.
P-Q2N5088 Transistor - 2N5088, Bipolar, General Purpose
2N5088 NPN Bipolar Junction Transistor in TO-92 package
P-QLM386N1 Integrated Circuit - LM386N-1/NOPB
LM386 Low Voltage Audio Power Amplifier The LM386 is a mono low voltage amplifier that can be used in a variety of applications. It can drive loads from 4 Ω to 32 Ω. The gain is internally set to 20 but it can be modified from 20 to 200 by placing a resistor and capacitor between pins 1 and 8. As this is an Op Amp it can be used in different configurations to fit in several applications. The internal gain setting resistor allows the LM386 to be used in a very low part count system. In addition a series resistor can be placed between pins 1 and 5 to modify the gain and frequency response for specific applications. These are found in many small audio amplifiers and even tiny pedal sized guitar amplifiers! There are tons of possibilities for this little Op Amp.
P-QOPAMPDD Op-Amp - Orange, Dual Discrete
The Dual Discrete op-amp is specially designed for audio and is among the most musical sounding dual discrete op-amps out there. It is available in DIP 8 format and can be used in any CD player, DAC, or preamplifier that currently runs DIP 8 based IC dual op-amp types.
The overall soundstage and transient detail will be greatly improved when used in pretty much all audio equipment that it can physically be fitted to. It has a very low noise Jfet front end so it can run with input impedances above 1M Ohms if needed. It can replace the following, provided the equipment it’s being used in has 22mm of height clearance and 5mm side clearance (per side).
  • OPA2604
  • OPA2134
  • TL072
  • NE5532
  • LM4562
  • OP275
  • OP285

Please check that the PSU can supply the extra current needed, especially if replacing more than one existing IC op-amp with our op-amp as with all discrete types, they do draw more current.
Don't see what you're looking for? Send us your product suggestions!