Semiconductors

Designed for full-wave triggering in Triac phase control circuits, half-wave SCR triggering application and as voltage level detectors. Used in most Peavey linear power amplifier designs through 2000 including CS/M/DECA series power amps, IPA300, and all models using 402/602/304S/204S power modules.

• Low Switching Voltage — 8 Volts Typical
• Uniform Characteristics in Each Direction
• Low On-State Voltage — 1.7 Volts Maximum
• Low Off-State Current — 0.1 mA Maximum

SJ-73180 (MJ21193), PNP output, 180V, 3A, TO-3 Case.

A18937 Transistor - Fender

Korg IC DG212CJ Used in certain Marshall amplifiers

SDS 7204, 300V, 10 mA, Case-30.

SJ-81180, NPN driver, 180V, 1A, TO-3 Case.

2N5088 NPN Bipolar Junction Transistor in TO-92 package

LM386 Low Voltage Audio Power Amplifier The LM386 is a mono low voltage amplifier that can be used in a variety of applications. It can drive loads from 4 Ω to 32 Ω. The gain is internally set to 20 but it can be modified from 20 to 200 by placing a resistor and capacitor between pins 1 and 8. As this is an Op Amp it can be used in different configurations to fit in several applications. The internal gain setting resistor allows the LM386 to be used in a very low part count system. In addition a series resistor can be placed between pins 1 and 5 to modify the gain and frequency response for specific applications. These are found in many small audio amplifiers and even tiny pedal sized guitar amplifiers! There are tons of possibilities for this little Op Amp.

The Dual Discrete op-amp is specially designed for audio and is among the most musical sounding dual discrete op-amps out there. It is available in DIP 8 format and can be used in any CD player, DAC, or preamplifier that currently runs DIP 8 based IC dual op-amp types.
The overall soundstage and transient detail will be greatly improved when used in pretty much all audio equipment that it can physically be fitted to. It has a very low noise Jfet front end so it can run with input impedances above 1M Ohms if needed. It can replace the following, provided the equipment it’s being used in has 22mm of height clearance and 5mm side clearance (per side).

• OPA2604
• OPA2134
• TL072
• NE5532
• LM4562
• OP275
• OP285

Please check that the PSU can supply the extra current needed, especially if replacing more than one existing IC op-amp with our op-amp as with all discrete types, they do draw more current.