Semiconductors

P-QMJ15022 Transistor - MJ15022, NPN, Power Transistor
Transistor MJ15022, TO-3 Case, NPN PowerBase power transistors designed for high power audio, disk head positioners and other linear applications. Features
  • High Safe Operating Area (100% Tested) −2 A @ 80 V
  • High DC Current Gain − hFE = 15 (Min) @ IC = 8 Adc
$7.50
P-QSBS14 Diode Thyristor - Peavey, SBS 14 Bidirectional, 8V, TO-92 Case
Designed for full-wave triggering in Triac phase control circuits, half-wave SCR triggering application and as voltage level detectors. Used in most Peavey linear power amplifier designs through 2000 including CS/M/DECA series power amps, IPA300, and all models using 402/602/304S/204S power modules.
  • Low Switching Voltage — 8 Volts Typical
  • Uniform Characteristics in Each Direction
  • Low On-State Voltage — 1.7 Volts Maximum
  • Low Off-State Current — 0.1 mA Maximum
$1.95
P-QLM324 Op-Amp - LM324, Quad, Low-Power, 14-Pin DIP
Quad low-power opamps in an 14-pin DIP package. The LM324 offers a 1MHz bandwidth and can be powered from a single supply.
$0.18
P-QOPAMPDD Op-Amp - Orange, Dual Discrete, Low-Noise, 8-Pin DIP
The Dual Discrete op-amp is specially designed for audio and is among the most musical sounding dual discrete op-amps out there. It is available in DIP 8 format and can be used in any CD player, DAC, or preamplifier that currently runs DIP 8 based IC dual op-amp types. The overall soundstage and transient detail will be greatly improved when used in pretty much all audio equipment that it can physically be fitted to. It has a very low noise Jfet front end so it can run with input impedances above 1M Ohms if needed. It can replace the following, provided the equipment it’s being used in has 22mm of height clearance and 5mm side clearance (per side).
  • OPA2604
  • OPA2134
  • TL072
  • NE5532
  • LM4562
  • OP275
  • OP285

Please check that the PSU can supply the extra current needed, especially if replacing more than one existing IC op-amp with our op-amp as with all discrete types, they do draw more current.
$46.75
Save 15%
Originally: $55.00
P-QA18937 Transistor - Fender®, A1837, amplifier application
A1837 Transistor - Fender. Power amplifier applications and Driver Stage Amplifier Applications.
$3.95
P-QMJ15023 Transistor - MJ15023, PNP, Power Transistor
Transistor MJ15023, TO-3 Case, PNP
PowerBase power transistors designed for high power audio, disk head positioners and other linear applications.
Features
  • High Safe Operating Area (100% Tested) −2 A @ 80 V
  • High DC Current Gain − hFE = 15 (Min) @ IC = 8 Adc
$6.00
P-QSJ73180 Transistor - Peavey, PNP 180V Output, SJ-73180, 180V, 3A
SJ-73180 (MJ21193), PNP output, 180V, 3A, TO-3 Case.
$8.50
P-QMJ15025 Transistor - MJ15025, TO-3 case, power
Transistor MJ15025, TO-3 Case The MJ15025 is a power transistor designed for high-power audio, disk head positioners, and other linear applications Features:
  • High Safe Operating Area: -2A @ 80 V
  • High DC Current Gain hFE = 15 (Min) @ IC = 8 Adc
$4.75
P-QSJ81180 Transistor - Peavey, NPN 140V Driver, SJ-81180, 180V, 1A
SJ-81180, NPN driver, 180V, 1A, TO-3 Case.
$8.25
P-QSJE2153 Transistor - Peavey, PNP Darlington, SJE 2153, 80V, 3A
SJE 2153 (TIP107), PNP Darlington, 80V, 3A, TO-3 Case.
$1.95
P-Q74LS175 Integrated Circuit - SN74LS175, Quadruple D-Type Flip-Flops, 16-pin DIP
This quad flip flop is a part used in our Relay True Bypass Switching Part 2: Momentary and Soft Touch Switches article. To read the full article and learn about a circuit for relay switching in stomp box effects, please see the following link. https://www.amplifiedparts.com/tech-articles/relay-true-bypass-switching-2 These monolithic, positive-edge-triggered flip-flops utilize TTL circuitry to implement D-type flip-flop logic. All have a direct clear input, and the '175, 'LS175, and 'S175 feature complementary outputs from each flip-flop. Information at the D inputs meeting the setup time requirements is transferred to the Q outputs on the positive-going edge of the clock pulse. Clock triggering occurs at a particular voltage level and is not directly related to the transition time of the positive-going pulse.
$1.10
P-QATTINY45 Integrated Circuit - ATtiny45, SN74LS175, 8-bit AVR Microcontroller, 8-pin DIP
This microcontroller is a part used in our Relay True Bypass Switching Part 3: Microcontrollers and Current Savings article. To read the full article and learn about a circuit for relay switching in stomp box effects, please see the following link. https://www.amplifiedparts.com/tech-articles/relay-true-bypass-switching-3 The high-performance, low-power Microchip 8-bit AVR RISC-based microcontroller combines 4KB ISP flash memory, 256-Byte EEPROM, 256B SRAM, 6 general purpose I/O lines, 32 general purpose working registers, one 8-bit timer/counter with compare modes, one 8-bit high speed timer/counter, USI, internal and external Interrupts, 4-channel 10-bit A/D converter, programmable watchdog timer with internal oscillator, three software selectable power saving modes, and debugWIRE for on-chip debugging.
$1.85
P-Q971 Diode - small signal fast switching, 1N4148A
A semiconductor device which passes current in the forward direction(from anode to cathode), and blocks current in the opposite direction. For extreme fast switches.
$0.50
P-Q972 Diode - 1N34A Germanium, low leakage
The 1N34A Germanium diode is an old standby in electronics. Widely used for detecting the rectifying efficiency or for switching on a radio, TV or stereo etc.
$1.75
P-QBS170 Transistor - Mosfet BS170, Small Signal
MOSFET BS170 N-Channel Transistor. Used in MOD® Kits.
Note - this is a fragile component! Use caution not to overheat or break leads.
$1.25
P-QMC78L05 Regulator - 5 Volt, Linear Voltage Regulator
5V Linear Regulator. Used in MOD® kits. This fixed-voltage monolithic integrated circuit voltage regulator is suitable for applications that required supply current up to 100 mA.
$0.50
R-VOP1020 Switch - Vibrato LDR, for Fender® Amps
Optocoupler. Vibrato LDR for Fender Amps. Fix the dead LDR-style tremolo on your vintage Fender amps as well as others.
  • Non-polarized optical side is indicated by silver dot and slightly longer leads
  • Resistive side is indicated only by slightly shorter leads
$8.95
P-Q1N474X Diode - Zener, 1W, 1N4741A, 1N4748A
A semiconductor device that, above a certain reverse voltage(the zener value) has a sudden rise in current. If forward biased, the diode is an ordinary rectifier. When reverse biased, it exhibits a sharp break in its current-voltage graph. Voltage across the diode remains essentially constant for any further increase of reverse current.
$0.20
P-QMPSA13 Transistor - MPSA13, Darlington 500mA 30V NPN
NPN Darlington transistor (TO-92 package) - designed for applications requiring extremely high current gain at collector currents to 1.0A.
  • Max collector to emitter voltage = 30 V
  • Max collector to base voltage = 30 V
  • Max emitter to base voltage = 10 V
  • Max collector current = 1.2 A (continuous)
$0.49
P-QPF5102 Transistor - JFET N-Ch Transistor Lo Freq / Lo Noise, PF5102
PF5102 N-Channel Switch (TO-92 package) - designed for low level analog switching, sample and hold circuits and chopper stabilized amplifiers.
  • Max drain to gate voltage = 40 V
  • Max gate to source voltage = -40 V
  • Max forward gate current = 50 m
$1.55
P-Q2N5088 Transistor - 2N5088, Bipolar, General Purpose
2N5088 NPN Bipolar Junction Transistor in TO-92 package
$0.20
P-Q1N53X Diode - Zener, 5 Watt, ±5% tolerance
5W zener diodes that are great for use in tube amps. These are commonly used to drop B+ voltages for tube modification compatibility or to create low power modes for the amp. A zener is a semiconductor device that, above a certain reverse voltage(the zener value) has a sudden rise in current. If forward biased, the diode is an ordinary rectifier. When reverse biased, it exhibits a sharp break in its current-voltage graph. Voltage across the diode remains essentially constant for any further increase of reverse current.
$0.55
Don't see what you're looking for? Send us your product suggestions!