Semiconductors

P-QMPS6533 Transistor - Peavey, MPS 6533, PNP Amplifier, 40V, TO-92
MPS 6533, PNP general purpose amp, 40V, TO-92 Case.
$2.00
P-QSJE2153 Transistor - Peavey, PNP Darlington, SJE 2153, 80V, 3A
SJE 2153 (TIP107), PNP Darlington, 80V, 3A, TO-3 Case.
$1.95
P-Q972 Diode - 1N34A Germanium
The 1N34A Germanium diode is an old standby in electronics. Widely used for detecting the rectifying efficiency or for switching on a radio, TV or stereo etc.
$1.75
P-QSJE5332 Transistor - Peavey, SJE 5332, 120V, 3A
SJE 5332, 120V, 3A, Case-77.
$1.65
P-QSBS14 Diode Thyristor - Peavey, SBS 14 Bidirectional, 8V, TO-92 Case
Designed for full-wave triggering in Triac phase control circuits, half-wave SCR triggering application and as voltage level detectors. Used in most Peavey linear power amplifier designs through 2000 including CS/M/DECA series power amps, IPA300, and all models using 402/602/304S/204S power modules.
  • Low Switching Voltage — 8 Volts Typical
  • Uniform Characteristics in Each Direction
  • Low On-State Voltage — 1.7 Volts Maximum
  • Low Off-State Current — 0.1 mA Maximum
$1.50
P-QSJE5331 Transistor - Peavey, SJE 5331, 120V, 3A
SJE 5331, 120V, 3A, Case-77.
$1.50
P-QSDS7204 Transistor - Peavey, SDS 7204, 300V, 10MA
SDS 7204, 300V, 10 mA, Case-30.
$1.45
P-QBS170 Transistor - Mosfet BS170, Small Signal
MOSFET BS170 N-Channel Transistor. Used in MOD® Kits.
Note - this is a fragile component! Use caution not to overheat or break leads.
$1.25
P-QMC78L05 Regulator - 5 Volt, Linear Voltage Regulator
5V Linear Regulator. Used in MOD® kits. This fixed-voltage monolithic integrated circuit voltage regulator is suitable for applications that required supply current up to 100 mA.
$1.25
P-QLM386N1 Audio Power Amplifier - LM386N-1, Low Voltage
LM386 Low Voltage Audio Power Amplifier The LM386 is a mono low voltage amplifier that can be used in a variety of applications. It can drive loads from 4 Ω to 32 Ω. The gain is internally set to 20 but it can be modified from 20 to 200 by placing a resistor and capacitor between pins 1 and 8. As this is an Op Amp it can be used in different configurations to fit in several applications. The internal gain setting resistor allows the LM386 to be used in a very low part count system. In addition a series resistor can be placed between pins 1 and 5 to modify the gain and frequency response for specific applications. These are found in many small audio amplifiers and even tiny pedal sized guitar amplifiers! There are tons of possibilities for this little Op Amp.
$1.25
P-QNE5532 Op-Amp - NE5532, Dual, Low-Noise, 8-Pin DIP
This a high performance dual low noise operational amplifier. Compared to the standard dual operational amplifiers, such as the NJM1458, it shows better noise performance, improved output drive capability, and considerably higher small-signal and power bandwidths. it is compensated internally for voltage follower circuit. This makes the device especially suitable for application in high quality and professional audio equipment, instrumentation, control circuits, and telephone channel amplifiers Features:
  • Operating Voltage = ±3V~±22V
  • Small Signal Bandwidth = 10MHz typ.
  • Output Drive Capability = 600Ω,10Vrms typ.
  • Input Noise Voltage = 5nV/√Hz typ.
  • Power Bandwidth = 140kHz typ.
  • Slew Rate = 8V/µs typ.
  • Bipolar Technology
$1.15
P-QTL074 Op-Amp - TL074, Quad, Low-Noise, JFET Input, 14-Pin DIP
Low noise JFET quad operational amplifier. Incorporates well matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. Features high slew rates, low input bias and offset currents, and low offset voltage temperature coefficients. Features:
  • Wide common-mode and differential voltage range
  • Low input bias and offset current
  • Low noise en = 15 nV/HZ
  • Output short-circuit protection
  • High input impedance JFET input stage
  • Low harmonic distortion: 0.01%
  • Internal frequency compensation
  • Latch up free operation
  • High slew rate: 16 V/us (typical)
$1.15
P-QBA4560 Op-Amp - BA4560, Dual, General Purpose, 8-Pin DIP
The BA4560, is a dual operational amplifiers which achieves approximately twice the high output current of the BA4558, as well as featuring a higher slew rate of 4V / µs, a gain band width of 10MHz, and an improved frequency characteristic. 8-pin DIP package.
$0.95
On Backorder
P-QBR-34 Bridge Rectifier - Single-phase, 3A 400V
A full wave rectifier with 4 elements in a bridge circuit so that DC voltage is obtained from one pair of junctions when an AC voltage is applied to another pair of junctions.
$0.95
P-Q2N2222A Transistor - 2N2222A, TO-18, NPN
The 2N2222A is a NPN transistor in a TO-18 metal case. The 2N2222A is commonly used in fuzz pedals.
$0.95
P-QTIP41C Transistor - TIP41C, NPN Epitaxial Transistor
Transistor TIP41C, TO-220 Case.
NPN Epitaxial Silicon Transistor
Complementary to TIP42 (P-QTIP42C)
Max ratings:
  • Collector-Base voltage = 100V
  • Collector-Emitter Voltage = 100V
  • Emitter-Base Voltage = 5V
  • Collector current (DC) = 6A
  • Collector current (Pulse) = 10A
  • Base current = 2A
$0.80
P-QTIP42C Transistor - TIP42C, PNP Epitaxial Transistor
Transistor TIP42C, TO-220 Case.
PNP Epitaxial Silicon Transistor
Complementary to TIP41 (P-QTIP41C)
Max ratings:
  • Collector-Base voltage = -100V
  • Collector-Emitter Voltage = -100V
  • Emitter-Base Voltage = -5V
  • Collector current (DC) = -6A
  • Collector current (Pulse) = -10A
  • Base current = -2A
$0.80
P-QLM741 Op-Amp - LM741, Single, 8-Pin DIP
LM741 single opamp in an 8-pin DIP package. The LM741 has been used in classic guitar pedals such as the Distortion Plus.
The LM741 series are general purpose operational amplifiers which feature improved performance over industry standards like the LM709. They are direct, plug-in replacements for the 709C, LM201, MC1439 and 748 in most applications. The amplifiers offer many features which make their application nearly foolproof: overload protection on the input and output, no latch-up when the common mode range is exceeded, as well as freedom from oscillations.
$0.79
P-QPT2399 Integrated Circuit - PT2399, Echo / Delay
PT2399 echo/delay chip used in many DIY and commercial pedals. The PT2399 is in a DIP 16 package. Minimal external components are required for use and delay time is set with resistance.
$0.78
P-Q4558 Op-Amp - 4558, Dual, 8-Pin DIP
Dual Operational Amplifier. The 4558 integrated circuit is a dual high-gain operational amplifier internally compensated and constructed on a single silicon chip using an advanced epitaxial process. Combining the features of the NJM741 with the close parameter matching and tracking of a dual device on a monolithic chip results in unique performance characteristics. Excellent channel separation allows the use of the dual device in single NJM741 operational amplifier applications providing density. It is especially well suited for applications in differential-in, differential-out as well as in potentiometric amplifiers and where gain and phase matched channels are mandatory. Features:
  • Operating Voltage (±4V~±18V)
  • High Voltage Gain (100dB typ.)
  • High Input Resistance (5MΩ typ.)
  • Bipolar Technology
$0.75
P-QPF5102 Transistor - JFET N-Ch Transistor Lo Freq / Lo Noise, PF5102
PF5102 N-Channel Switch (TO-92 package) - designed for low level analog switching, sample and hold circuits and chopper stabilized amplifiers.
  • Max drain to gate voltage = 40 V
  • Max gate to source voltage = -40 V
  • Max forward gate current = 50 m
$0.75
P-QTL072 Op-Amp - TL072, Dual, Low-Noise, JFET Input, 8-Pin DIP
The TL072 is a high speed JFET input dual operational amplifier incorporating well matched, high voltage JFET and bipolar transistors in a monolithic integrated circuit. The device features high slew rates, low input bias and offset current, and low offset voltage temperature coefficient.
$0.70
P-L300X LED - 3mm diameter, diffused lens
Package of 5
Colors Available:
Lens Diameter: 3 mm Overall Height: 5.4 mm Lens Type: Diffused Multiple color options available.
$0.65
P-Q971 Diode - small signal fast switching, 1N4148A
A semiconductor device which passes current in the forward direction(from anode to cathode), and blocks current in the opposite direction. For extreme fast switches.
$0.50
Don't see what you're looking for? Send us your product suggestions!