Semiconductors

P-Q4558 Op-Amp - 4558, Dual, 8-Pin DIP
Dual Operational Amplifier. The 4558 integrated circuit is a dual high-gain operational amplifier internally compensated and constructed on a single silicon chip using an advanced epitaxial process. Combining the features of the NJM741 with the close parameter matching and tracking of a dual device on a monolithic chip results in unique performance characteristics. Excellent channel separation allows the use of the dual device in single NJM741 operational amplifier applications providing density. It is especially well suited for applications in differential-in, differential-out as well as in potentiometric amplifiers and where gain and phase matched channels are mandatory. Features:
  • Operating Voltage (±4V~±18V)
  • High Voltage Gain (100dB typ.)
  • High Input Resistance (5MΩ typ.)
  • Bipolar Technology
$0.75
P-QTL072 Op-Amp - TL072, Dual, Low-Noise, JFET Input, 8-Pin DIP
The TL072 is a high speed JFET input dual operational amplifier incorporating well matched, high voltage JFET and bipolar transistors in a monolithic integrated circuit. The device features high slew rates, low input bias and offset current, and low offset voltage temperature coefficient.
$0.70
P-QNE5532 Op-Amp - NE5532, Dual, Low-Noise, 8-Pin DIP
This a high performance dual low noise operational amplifier. Compared to the standard dual operational amplifiers, such as the NJM1458, it shows better noise performance, improved output drive capability, and considerably higher small-signal and power bandwidths. it is compensated internally for voltage follower circuit. This makes the device especially suitable for application in high quality and professional audio equipment, instrumentation, control circuits, and telephone channel amplifiers Features:
  • Operating Voltage = ±3V~±22V
  • Small Signal Bandwidth = 10MHz typ.
  • Output Drive Capability = 600Ω,10Vrms typ.
  • Input Noise Voltage = 5nV/√Hz typ.
  • Power Bandwidth = 140kHz typ.
  • Slew Rate = 8V/µs typ.
  • Bipolar Technology
$1.15
P-QSJE5331 Transistor - Peavey, SJE 5331, 120V, 3A
SJE 5331, 120V, 3A, Case-77.
$1.50
P-QSJE5332 Transistor - Peavey, SJE 5332, 120V, 3A
SJE 5332, 120V, 3A, Case-77.
$1.65
P-Q2N3055 Transistor - 2N3055, High Power NPN Silicon, TO-3 Case
15 A, 60 V, 115 W
EPIBASE - Designed for power amplifier and switching regulator applications. The best choice where high frequency response, low switching losses and good safe operating area are required.
  • Current Gain - Bandwidth Product - fT = 2.5 MHz (Min) @ Ic = 1.0 Adc
  • Safe Operating Area - Full Power Rating to 40 V
$2.25
P-QTIP42C Transistor - TIP42C, PNP Epitaxial Transistor
Transistor TIP42C, TO-220 Case.
PNP Epitaxial Silicon Transistor
Complementary to TIP41 (P-QTIP41C)
Max ratings:
  • Collector-Base voltage = -100V
  • Collector-Emitter Voltage = -100V
  • Emitter-Base Voltage = -5V
  • Collector current (DC) = -6A
  • Collector current (Pulse) = -10A
  • Base current = -2A
$0.80
P-QMJ15016 Transistor - MJ15016, PNP, Complementary High-Power
Transistor MJ15016, TO-3 Case, PNP
PowerBase complementary transistors designed for high power audio, stepping motor and other linear applications. These devices can also be used in power switching circuits such as relay or solenoid drivers, dc–to–dc converters, inverters, or for inductive loads requiring higher safe operating areas.
Safe Operating Area - Rated to 60V
$2.85
P-QTIP41C Transistor - TIP41C, NPN Epitaxial Transistor
Transistor TIP41C, TO-220 Case.
NPN Epitaxial Silicon Transistor
Complementary to TIP42 (P-QTIP42C)
Max ratings:
  • Collector-Base voltage = 100V
  • Collector-Emitter Voltage = 100V
  • Emitter-Base Voltage = 5V
  • Collector current (DC) = 6A
  • Collector current (Pulse) = 10A
  • Base current = 2A
$0.80
P-QMJ15015 Transistor - MJ15015, NPN, Complementary High-Power
Transistor MJ15015, TO-3 Case, NPN
PowerBase complementary transistors designed for high power audio, stepping motor and other linear applications. These devices can also be used in power switching circuits such as relay or solenoid drivers, dc–to–dc converters, inverters, or for inductive loads requiring higher safe operating areas.
Safe Operating Area - Rated to 60V
$2.85
P-QTL082 Op-Amp - TL082, Dual, Wide-Bandwidth, JFET Input, 8-Pin DIP
Dual wide-bandwidth TL082 opamps in an 8-pin DIP package. The TL082 offers a high input impedance and 4MHz bandwidth.
$0.21
P-QMPS6531 Transistor - Peavey, MPS 6531, NPN Amplifier, 40V, TO-92
MPS 6531, NPN general purpose amp, 40V, TO-92 Case.
$2.00
P-QTL074 Op-Amp - TL074, Quad, Low-Noise, JFET Input, 14-Pin DIP
Low noise JFET quad operational amplifier. Incorporates well matched, high-voltage JFET and bipolar transistors in a monolithic integrated circuit. Features high slew rates, low input bias and offset currents, and low offset voltage temperature coefficients. Features:
  • Wide common-mode and differential voltage range
  • Low input bias and offset current
  • Low noise en = 15 nV/HZ
  • Output short-circuit protection
  • High input impedance JFET input stage
  • Low harmonic distortion: 0.01%
  • Internal frequency compensation
  • Latch up free operation
  • High slew rate: 16 V/us (typical)
$1.15
P-QLF353 Op-Amp - LF353, Dual, Wide-Bandwidth, JFET Input, 8-Pin DIP
Dual wide-bandwidth LF353 opamps in an 8-pin DIP package. The LF353 offers a high input impedance and 3MHz bandwidth.
This LF353 device is a low-cost, high-speed, JFET input operational amplifier with very low input offset voltage. It requires low supply current yet maintains a large gain-bandwidth product and a fast slew rate. In addition, the matched high-voltage JFET input provides very low input bias and offset currents.
$0.34
P-QTL062 Op-Amp - TL062, Dual, Low-Power, JFET Input, 8-Pin DIP
Dual low power opamps in an 8-pin DIP package. The TL062 offers a high input impedance and 1MHz bandwidth.
$0.28
P-Q2N5400 Transistor - Peavey, 2N5400, PNP Amp, 120V, 20MA, TO-92
2N5400 (761), PNP general purpose amp, 120V, 10mA, TO-92 case.
$0.45
P-QBA4560 Op-Amp - BA4560, Dual, General Purpose, 8-Pin DIP
The BA4560, is a dual operational amplifiers which achieves approximately twice the high output current of the BA4558, as well as featuring a higher slew rate of 4V / µs, a gain band width of 10MHz, and an improved frequency characteristic. 8-pin DIP package.
$0.95
P-QQ4025P Triac - Q6025P5 - Alternistor, 600V, 25A, Fastpack TO-3 Base
Alternistors are specifically designed for applications which are required to switch highly inductive loads. To accomplish this, a special chip has been designed which effectively offers the same performance as two thyristors (SCRs) wired inverse parallel (back to back); hence the alternistor has better turn-off behavior than a standard triac.
$14.95
On Backorder
P-QLM741 Op-Amp - LM741, Single, 8-Pin DIP
LM741 single opamp in an 8-pin DIP package. The LM741 has been used in classic guitar pedals such as the Distortion Plus.
The LM741 series are general purpose operational amplifiers which feature improved performance over industry standards like the LM709. They are direct, plug-in replacements for the 709C, LM201, MC1439 and 748 in most applications. The amplifiers offer many features which make their application nearly foolproof: overload protection on the input and output, no latch-up when the common mode range is exceeded, as well as freedom from oscillations.
$0.79
P-Q2N2222A Transistor - 2N2222A, TO-18, NPN
The 2N2222A is a NPN transistor in a TO-18 metal case. The 2N2222A is commonly used in fuzz pedals.
$0.95
P-Q2N3904 Transistor - 2N3904, TO-92, NPN
General purpose low-power NPN bipolar junction transistor, used frequently in hobbyist electronic projects.
$0.18
P-Q2N5089 Transistor - 2N5089, TO-92, NPN
General purpose low level, low noise amplifier. Silicon NPN transistor.
$0.30
P-QBC550 Transistor - BC550, TO-92, NPN
Low noise transistor for audio frequency amplifier applications.
$0.19
P-QMJ15023 Transistor - MJ15023, PNP, Power Transistor
Transistor MJ15023, TO-3 Case, PNP
PowerBase power transistors designed for high power audio, disk head positioners and other linear applications.
Features
  • High Safe Operating Area (100% Tested) −2 A @ 80 V
  • High DC Current Gain − hFE = 15 (Min) @ IC = 8 Adc
$6.00
Don't see what you're looking for? Send us your product suggestions!