Retainer - for EL84 Tubes
Tube retainer for EL84. for use with guitar amps and applications where the tube is suspended upside down in the chassis. Supports a maximum tube height of 2.8 inches
|Max Tube Height||2.8 in.|
|Mounting Center Distance A||1.125 in.|
|Packaging Dimensions||3.1 in. × 1.1 in. × 0.8 in.|
|Weight (Packaging)||0.005 lbs.|
My Project Lists
Questions and Answers
Click each question to see its answers.
1 answers Would this be a good retainer to use with a 12BH7?
Asked by Anonymous on April 6th, 2017. 1 person subscribed to this question
The 12BH7 will be too short for this retainer.
1 answers How do you install these?
Asked by Anonymous on August 22nd, 2017. 1 person subscribed to this question
These attach around your tube sockets. The top of the retainers attach to the exhaust tip of the tube to secure it in place.
1 answers Will these retainers work with the Belton, 9 pin, miniature, top mount sockets you sell? Part number: P-ST9-600.
Asked by Anonymous on June 6th, 2018. 1 person subscribed to this question
The hole patten does line up on both of these parts and they should work with each other.
1 answers What is the easiest way to get these wire retainers over an EL84 tube? I've been using needle nose pliers to stretch the wire over the top of the tube due to the tight fit.
Asked by Anonymous on October 26th, 2018. 1 person subscribed to this question
These retainers are designed for a tight fit to keep your tubes secure. Make sure the gap on the top of the retainer is facing the tube itself (with the pull tab facing the opposite direction) before you begin to put the tube in place. The ring on top should slip in place around the top of the tube.
Have a question of your own? Ask us now!