Power Supplies & Accessories

P-H217 PCB - Marshall, Valve PCB TSL100/TSL122, Rev 20
Marshall PC Board for TSL 100 / 122. Rev 20. Marshall Part: M-TL10-60-02-01
$212.63
Save 10%
Originally: $236.25
M-PP100 Attenuator - Recycled Sound, Power Plug 100, -30dB
The Power Plug 100 offers the same -10db as the Power Plug Lite (M-PPLITE) but adds another "Bedroom Level" pot for further attenuation of up to -30db AND is suitable for amps up to 100 watts!
Turn your tube amp UP to drive your power tubes. This is where tube amps blossom and where players get in trouble. Use the attenuator to drop your overall volume to more tolerable levels. You can dial in your breakup, which may be too loud, then attenuate to lower the overall volume. So you can adjust your amp as usual and use the attenuator as an overall Master volume.
$170.96
Save 10%
Originally: $189.95
On Backorder
M-PPLITE Attenuator - Recycled Sound, Power Plug Lite, -10dB
The Power Plug Lite offers up to -10db attenuation in a rotary switch with -2db increments. The Power Plug Lite will accept all impedances and is rated for up to 50 watt amps. The same cool extruded aluminum case as the original Power Plug (M-ATT-6-12) for those who want a lighter touch and more control.
Turn your tube amp UP to drive your power tubes. This is where tube amps blossom and where players get in trouble. Use the attenuator to drop your overall volume to more tolerable levels. You can dial in your breakup, which may be too loud, then attenuate to lower the overall volume.
$103.46
Save 10%
Originally: $114.95
M-ATT-6-12 Attenuator - Recycled Sound, ~\frac{6}{12}~, -12dB, 8Ω
Recycled Sound NEW 6/12 Attenuator. 8 ohms. Why 6/12? Engage 1 switch and remove -6db of power. Engage the 2nd switch and you're -12db.
$80.96
Save 10%
Originally: $89.95
P-H214 Power Board Kit - Marshall, For AVT Series
Marshall replacement power board.
Works in the following models:
  • AVT50
  • AVT100
  • AVT150H
  • AVT150
  • AVT275
  • AVT275X
$59.94
Save 10%
Originally: $66.60
M-PAS-D Kit - Power All System deluxe, for effects pedals
The Power-All Deluxe Kit provides 9 volts DC at 2000 milliamps @ more than enough current to power dozens of effect pedals, including up to 4 Line 6 Modelers! The Power-All Deluxe Kit can power eleven pedals out of the box, and comes complete with a variety of jumper cables that allow connection of phone plug, reverse polarity, digital, and battery-only pedal types.
$35.96
Save 10%
Originally: $39.95
M-K080 Power Supply - Korg, 12V, 1500mA, Center Positive
Korg Power Supply, KA-310 adapter for X50, MicroX, R3, MR1000, or SP170.
Please note that this requires an AC power cord to make it useable. We sell this cord and the part number is S-W128.
$33.12
Save 10%
Originally: $36.80
M-K040 Power Supply - Korg, 12V, 1500mA, Center Negative
For use with KP-1, X5D, X5DR, SP100, KAOSSPAD and 05R/W.
$30.56
Save 10%
Originally: $33.95
On Backorder
P-HFAN Fan - 115V, AC ~\frac{50}{60}~ HZ, 1 Phase
Super low noise 115V-AC. Dimensions are 4 11/16" (height) x 4 11/16" (width) x 1 ½" (depth). The distance between mounting centers is 4 1/8" x 4 1/8".
$23.36
Save 10%
Originally: $25.95
S-W102-X Wire - 18 Gauge Braided Power Cord
Brown 2 conductor 18 gauge, stranded power cord, similar to woven cloth covered cords in early AC radios. 105°C temperature rating, 600V.
Starting at $22.50
Save 10%
Originally: $25.00
M-PAS-B Kit - Power All System Basic, For Effects Pedals
The Power-All PA-9 Digital Power Supply is the world’s first 2000 mA, single outlet power supply designed specifically for guitar effect users. Don’t waste money on batteries or take up valuable space with multiple “wall wart” adaptors or power bricks – the Power-All system can power your entire pedalboard from a single power supply that takes up only one outlet! The Power-All provides 9 volts DC at 2000 milliamps – more than enough current to power dozens of effect pedals, including up to four Line 6 Modelers! The Power-All’s special circuit design offers the lowest noise floor of any digital power supply on the market. The PA-9 now comes with a ferrite-core filter built onto its output cable to further reduce noise and hum.
$22.46
Save 10%
Originally: $24.95
M-PAS-S Power Supply - Power-All System, 9V, 2000mA, for Effects Pedals
The PA-9 Power-All is the world's first 2000 mA, single outlet power supply designed specifically for guitar effect users. Don't waste money on batteries or take up valuable space with multiple "wall wart" adaptors or power bricks - the Power-All system can power your entire pedalboard from a single power supply that takes up only one outlet! The Power-All's special circuit design offers the lowest noise floor of any digital power supply on the market. The PA-9S now comes with a ferrite-core filter built onto its output cable to further reduce noise and hum.
$17.96
Save 10%
Originally: $19.95
P-HLOBAT Low Battery Indicator - PMT, LoBat, for Active Electronics
Designed for use with active pickups and electronics that use 9 volt batteries. Lights when battery voltage is below 7.7V. This early warning notifies the player it's time for a new battery before tone begins to suffer. The P-HLOBAT has a very low current draw that will not have a noticeable reduction on battery life.
$17.96
Save 10%
Originally: $19.95
P-ECB-9V2 Battery Box - Gotoh, Dual, 9 Volt
Dual 9 volt battery box. Two 9V battery compartments, each compartment having its own red and black wires for battery positive and negative connections (4 wires total) allowing for series, parallel or separate connections of two 9V batteries.
Four wood screws included.
Directions:
1. Refer to the Drawing B and make a hole on guitar body. 57.5 mm (2.26") x 49.5 mm (1.95"), R6 (6 mm = 0.24")
2. Put the box in guitar body and fix it by screws.
$17.10
Save 10%
Originally: $19.00
M-PAS-CABLE-2 Cable - For Power All Systems, C-11/R
Designed for larger pedalboards, the Power-All Cable-11/R Daisy Chain features ELEVEN right-angle male barrel plugs with spring loaded jacks for extra secure connections – no more losing power mid-solo! 28-gauge cable with oil-resistant sheath and 10-inch cable length between plugs allows connection of larger and odd-sized pedals.
Plugs: (11): Diameter 5.5 mm external, 2.1 mm internal. Barrel length: 10 mm. Spring-loaded right-angle male plugs
Cable length: 3962.4 mm (approximately 156 inches) total, 270 mm (10.5") between jacks.
Whether you’re using the Power-All digital Power Supply or another manufacturers’ multi-output power brick, Power-All cables are the best way to assure that your pedals are getting the power they need - when and where they need it.
$13.50
Save 10%
Originally: $15.00
M-K050 Power Supply - Korg, 9V, 500mA~1.2A, Center Negative
For use with MS2000, microKONTROL, microKORG, Etribes, DT7, AX1G/B, AX100G, AX1500, GT12, OT12, and PX3/3B.
$13.05
Save 10%
Originally: $14.50
P-ECB-9V1A Battery Box - Gotoh, single, 9 volt
Single 9 volt battery box.
See P-ECB-9V1B for single battery box with removable adapter.
See P-ECB-9V2 for double battery box.
$12.56
Save 10%
Originally: $13.95
P-ECB-9V1B Battery Box - Gotoh, single, 9 volt, with removable adapter
Single 9 volt battery box.
See P-ECB-9V1A for single battery box without removable adapter.
See P-ECB-9V2 for double battery box.
$12.56
Save 10%
Originally: $13.95
On Backorder
P-ECB-002 Power Supply - Dunlop, 9V, 200mA, 3.5mm Positive Tip
Dunlop ECB002 US wallwart power supply. 3.5mm connector.
  • Voltage: 9VDC
  • Current: 200mA
  • Tip positive; Sleeve negative
$10.58
Save 10%
Originally: $11.75
P-ECB-003 Power Supply - Dunlop, 9V, 200mA, Barrel, Center Negative

Dunlop ECB003 US wallwart power supply. Barrel connector.

  • Voltage: 9VDC
  • Current: 200mA
  • Tip Negative; Sleeve positive
$10.58
Save 10%
Originally: $11.75
S-W128 Cord - Korg, AC Power, UC-1800-U02LY
AC power cord for the Korg KA-310 power adapter (part number M-K080).
$8.96
Save 10%
Originally: $9.95
M-K020 Power Supply - Korg, 4.5V, 500mA, Center Positive
Korg KA-193 wallwart power supply. For use with PX4, PX4B and PXR4.
  • Voltage: 4.5VDC
  • Current: 500mA
  • Tip positive; Sleeve negative
$8.51
Save 10%
Originally: $9.45
M-PAS-CABLE-1 Cable - For Power All Systems, C-5/R
Right Angle Daisy Chain connector with standard polarity tip negative/barrel positive plugs connects the PA-9 Power-All to five effect pedals. The Cable-5/R can also be used with Power-All jumper cables to power effects that use different style jacks (reverse polarity, phone plug, battery clip, etc.).
You can also link multiple Cable-5/R connectors to power over twenty 9-volt effect pedals or similar devices (actual number of units depends on current draw of individual units used).
Plugs: (5): Diameter 5.5 mm external, 2.1 mm internal. Barrel length: 10 mm. Spring-loaded right-angle male plugs prevent accidental disconnection from power source or pedal.
Cable length: 1397 mm (55”) total, 270 mm (10.5") between jacks.
Whether you’re using our Power-All digital Power Supply or another manufacturers’ multi-output power brick, Power-All cables are the best way to assure that your pedals are getting the power they need - when and where they need it.
$6.75
Save 10%
Originally: $7.50
S-W131 Cord - Power, European, 2.5M
Detachable 3 conductor power cord for European wall outlets.
GTSA-3 (Marshall™ type) 18 AWG. 2-1/2 meters (about 8 feet) length, 1/4” outer diameter.
$5.36
Save 10%
Originally: $5.95
Don't see what you're looking for? Send us your product suggestions!