New Products

C-UD0033-400 Capacitor - 400V, Polypropylene, Axial Leads, .0033 uF
General purpose polypropylene film capacitor.
  • Dissipation Factor: 0.001 Max at 1000 Hz and 25°C , 0.004 Max at 10 kHz and 25°C
  • Temperature Coefficient: -200 PPM/°C: -100 PPM/°C, 100 PPM/°C
  • ESR: 53.588 Ohms at 1 kHz and 20°C
  • Self Inductance: 1 Nanohenries maximum per mm of body length and lead length
  • dvdt: 15 V/µs
  • Tolerance: -10 % , +10 %
  • Temperature Range: -55°C to +105°C
    • Above 85°C the rated (DC/AC) voltage must be derated at per 1.25%°C
  • WVDC: 400 Volts DC
  • VAC: 220 Volts AC
  • Terminal to Terminal Dielectric strength: 1.6 times the rated DC voltage when applied between the terminals for 2 seconds
  • Terminal to case Dielectric strength: 2 VAC when applied between the terminals and case for 2~5 seconds
  • Insulation Resistance (Terminal to Terminal): 30000 MINIMUM after 100 Volts DC is applied for 60 seconds at 20°C
  • Insulation resistance (Termi
$0.69
W-RN-920 Plug - Rean, 3.5mm, Mono, 2 Pole, Cable-Mount
High quality 3.5mm two pole (mono) plug. Features nickel plated brass contacts, with a nickel plated zinc shell. This plug uses a crimp strain relief for use with 4mm O.D cables.
See W-RN-921 for stereo version.
$0.95
S-H8FW Finishing Washer - #8, Blackface/Silverface, Nickel Plated Steel
Pack of 10 nickel plated steel finishing washers. These high quality washers closely resemble the washers found on many vintage blackface and silverface amplifiers. Fits with #8 countersunk screws.
$1.00
W-RN-921 Plug - Rean, 3.5mm, Stereo, 3 Pole, Cable-Mount
High quality 3.5mm three pole (stereo) plug. Features nickel plated brass contacts, with a nickel plated zinc shell. This plug uses a crimp strain relief for use with 4mm O.D cables.
See W-RN-920 for mono version.
$1.15
P-H1050 Corner - Black Plastic, 4-Hole, Replacement for Vox / Orange
These Tube Amp Doctor black plastic corners are great replacements for Vox® and Orange® amps and cabinets that feature this type. The two larger holes are for use with screws while the small holes are intended for pins/nails just like the originals.
$1.25
S-H901-PC-S-L Jack - Cliff, ¼", Stereo, PC Mount, L-Leg
Cliff S4 PC-A (L Leg). Stereo input jack, metal nut, 6 pin pc mount. Low-noise Ni-Ag® Alloy Self-Cleaning Contacts for superior performance and reliability Tough, molded grade 1 black Nylon body. Supplied with a black nylon hexagonal mounting nut. Designed to receive both mono and stereo ¼" jack plugs.
$1.95
W-AM-AC3FJ XLR Plug - Amphenol, 3-Pole, Female, Large Jaw, Nickel
XLR 3 pole female, stamped contacts, large jaws cable clamp.
$2.35
P-H336X Handle - Modern Style, Black Grip, Die-cast Ends
This handle has a flexible molded black grip with two rugged die-cast mounts. There are two holes per mount for use with M4 screws. See specifications below for dimensions.
$2.95
S-PAP-X Guitar Picks - Tortex, 351, Amplified Parts
High quality Tortex guitar picks in the classic 351 shape. These durable picks have a fine matte surface that grips well to fingers while offering a fast attack on strings. Sold in packs of 5 picks.
$3.80
P-H498-X Switch - Footswitch, DPDT, Vintage Style
Heavy duty footswitch with vintage style solder lugs. Great replacement for stomp-box effects requiring a DPDT (Double Pole, Double Throw) switch. AC125V/4A AC250V/2A.
$3.95
S-H650X Jack - Pure Tone, ¼", Mono, 2-Conductor, Open Circuit
Colors Available:
Pure Tone has developed a high quality 1/4" two pole (mono) jack using a new patented design that improves upon and offers a more reliable connection than standard 1/4" jacks. The Pure Tone design features two springs per pole that secure the plug into place and create a 100% greater surface area connection at all contact points to improve stability and signal integrity. These jacks also increase the current capability of 1/4" connections.
Starting at $4.20
P-K451 Knob - Marshall, Brown, Gold Cap, Push-On
Genuine Marshall® knob for 18 teeth knurled pot shafts. Used on the MG100HDFX, G100RCD, and other models. Sold individually.
$4.25
S-CMP19 Refill Pack for Ultimate Fret Polishing System - Lizard Spit
This pack includes 24 fresh fret polishing pads for use with the Lizard Spit Ultimate Fret Polishing System, S-CMP15.
$4.50
S-H651X Jack - Pure Tone, ¼", Stereo, 3-Conductor, Double Open Circuit
Colors Available:
Pure Tone has developed a high quality 1/4" three pole (stereo) jack using a new patented design that improves upon and offers a more reliable connection than standard 1/4" jacks. The Pure Tone design features two springs for both the tip connection, a spring for the ring, and an additional spring for the shield connection. These help to secure the plug into place and create a greater surface area connection at contact points to improve stability and signal integrity. These jacks also increase the current capability of 1/4" connections.
Starting at $5.20
R-V250K-PAN Potentiometer - Fender®, 250K, Pan, MN Taper, Solid Shaft
Genuine Fender® 250K pan pot with center detent. Pan pots are also known as balance pots. Solid shaft with 3/8” bushing. Mounting hardware not included. See R-VNUT-38 for a compatible nut and washer.
$5.65
P-K337-RW Switch Tip - Fender®, Stratocaster, Road Worn®, Set Of 2
Original Fender switch tips. Pack of 2
$5.75
P-GTSB04-RW Strap Buttons - Fender®, Vintage, Road Worn®, Set of 2
Original Fender® Road Worn® vintage strap buttons. Designed to fit most Fender instruments. Relic’d mounting screws included.
$5.75
P-A-GASKET-E-12 Gaskets - Eminence, Replacement Set
(Package of 4)
Set of four genuine Eminence® replacement gaskets for one 12" speaker. ¼" thick, durable foam with adhesive on one side for mounting.
$6.00
P-PGA1-RW Pickguard Screws - Fender®, Road Worn®, Set of 24
Original Fender® Road Worn® pickguard screws. Package of 24.
$6.95
P-GTSG-STRAT-RW String Guide - Fender®, for Stratocaster, Road Worn®
Original Fender® Road Worn string guide with mounting screw and spacer.
$8.50
P-H225 Vent - Brass, Replacement for Vox / Marshall
Tube Amp Doctor has created an exact replica of the vents used on Vox® amps and the Marshall® Super PA. These high quality brass ventilation grills are hand crafted. Measures 0.720" x 4.805".
$8.50
P-GTSG-TELE-RW String Guide - Fender®, for Telecaster, Road Worn®
Original Fender® Road Worn® string guide with mounting screw.
The Fender® Road Worn® series is comprised of genuine Fender® parts that have been crafted to look and feel like a truly vintage part. All parts are designed to the same specs as originals and feature patina and signs of a well played guitar part. Fender® Road Worn® parts won’t stick out like a sore thumb on vintage and relic’d guitars.
$8.95
S-T312 String Cutters - Dunlop, System 65
The Dunlop System 65 Sting Cutter can cut through any strings. It will cut through .130” thick bass strings just as easily as a .010” guitar string. This is a great tool to keep nearby, easily fitting in a case or gig bag.
$9.95
S-T311 Screwdriver - Dunlop, System 65
The Dunlop System 65 Screwdriver is the perfect small sized tool for a gig bag or case. The four bits include two different Phillips heads and two different flat heads which can cover almost any screw used on guitars and basses.
$9.95
Don't see what you're looking for? Send us your product suggestions!