Luthier Parts & Tools
Nut blanks - Fender®, plastic, set of 2
Package of 2Blank string nuts for Fender® guitars made of plastic
Nut - Brass, for Fender, blank un-slotted
This brass nut blank will work for most Fender® and similar style guitars and basses. It is NOT slotted and does require final shaping and fitting to exact size.
- Thickness = 9/64 inches (3.47mm)
- Flat Bottom Length = 1 11/16 inches (43 mm)
- Height at ends = 13/64 inches (5.25mm)
- Height at middle = 15/64 inches (6mm)
Nut - Bone, for Gibson, 43mm X 5.9mm X 8mm, Flat
Bone nut for Gibson®, 43mm x 5.9mm x 8mm at highest point with flat bottom.
Nut - Gold Tone, Zero Glide Blank (Unslotted)
The Zero Glide® Replacement Nut System borrows the “zero fret” concept to reduce string contact in the nut by up to 93%, increasing tuning stability, playability, and open string tone. It only take a few minutes to install with absolutely no permanent alteration to your instrument. Zero fret wire included (multiple sizes). Comparison Standard Nut Zero Glide Open String Tone Absorbs energy. Fret reflects energy, making the open strings more vibrant. Tuning Friction causes string binding. 93% less surface area. More accurate tuning. String Bend/Whammy Bar Whammy bars and string bends cause the strings to bind in the nut and not return to pitch Reduces string binding and "returns to zero" after every tug of the whammy bar or bend Intonation Large pitch deviation in early frets. (See intonation graph below) Minimal pitch deviation in early frets.
Nut - Bone, for Fender, 44.45mm X 3.3mm X 6.35, Flat
Bone nut for Fender® , 44.45mm x 3.3mm x 6.35mm at highest point with flat bottom.
Nut - Graphite, for Fender, blank unslotted
This graphite nut blank will work for most Fender® and similar style guitars and basses. It is NOT slotted and does require final shaping and fitting to exact size. It has a radiused bottom.
- Length = 2 1/64 inches (51.25mm)
- Height = 11/64 inches (4.55mm)
- Thickness = 1/8 inch (3.1mm)
Nut - Graphite, for Gibson, slotted
This graphite nut will work for most Gibson® and similar style guitars and basses. It is slotted but does require final shaping and fitting to exact size. PLEASE NOTE: Because this nut tapers in both thickness from top to bottom and height on the fret board side vs. the headstock side all measurements for those dimensions were taken at the center of the nut.
- Length = 1 23/32 inches (43.75mm)
- Height #1 (fretboard side) = 5/16 inches (7.81mm)
- Height #2 (headstock side) = 9/32 inches (7mm)
- Thickness at bottom = 15/64 inches (6.1mm)
- Thickness at top = 3/16 inches (4.78mm)
Nut - Tusq , Pre-shaped Blank, Acoustic, Martin Style
The PQ-M100-00 is a TUSQ nut blank specially designed to be used on Martin style guitars. It has an angled bottom and needs to be slotted. Dimensions:
- Length - 1.89 in. (48.01mm)
- Width - 0.226 in. (5.74mm)
- Height - 0.42 in. (10.67mm)