Keyboard Parts

Capacitor - Electrolytic, 30/30/30/10 µF @ 475 VDC Drop-In replacement for Leslie 4 section 30uF/30uF/30uF/10uF @ 475V For use in Leslie 122, 147, many others. CE Manufacturing capacitors are hand made in the USA using original Mallory Equipment. All CE manufactured can capacitors have a two year warranty against manufactured defects.

For N364 and X5, 5 are required. for N264, 2 are needed. May be cut. Sold individually. These are also used in the Kurzweil MK (MARK)-Series of electronic pianos.

Replacement upper drive belt , 25.5" circumference

Korg condensor microphone EM197K.

Lower slow motor rebuild kit for Leslie models 122/147. Includes installation instructions.

Upper slow motor rebuild kit fits Leslie models 122/147. Includes installation instructions.

Replacement relay for Leslie Model 122, 110 VDC, 5 K , SPDT. The contacts are rated at 10A.

For Yamaha DX7, DX7 II, FX20, Korg M1, Trinity and T Series.

Replacement lower drive belt, white, 31" circumference.

6 pin male plug with wavy washer, for Leslies.

Replacement relay for Leslie model 147 amplifier, 115 VAC , SPDT. The contacts are rated at 10A.

Replacement rubber O ring for the Leslie 122 and 147 cabinets.

Replacement upper slow motor assembly for Leslie models 122/147. Overall shaft length is 2.75".

6 pin female socket with wavy washer, for Leslies.

Switch for run circuit in Hammond Organ. Electrical Rating: 16 A - 125 V 8 A - 250 V Dimensions: Mounting Diameter: ½" Bushing Length: 0.425" Length: 1.89" Width: 0.82" Depth: 0.69"

For use with MS2000, microKONTROL, microKORG, Etribes, DT7, AX1G/B, AX100G, AX1500, GT12, OT12, and PX3/3B.

17" rotor cover fits Leslie models 122/147.

Set of 13 phillips head screws for Leslies. Includes 13 flat washers. 13 pieces replaces all of the screws on the upper cover, lower cover and middle back panel.

Korg KA-163E / YP-055 power supply. For use with AM8000R, D8, D12, D16, DL8000R, KARMA, KM2, N1, N1R, N5, N5EX, SP500, TR Series, Triton LE

• Voltage: 9VAC
• Current: 3000mA
• 4 pin connector

Replacement lower slow motor assembly for Leslie models 122/147. Overall shaft length is 2.75".

Plug cover kit for Leslie , screws included. This is the connector cap for the connecting cable.

KA-193 wallwart power supply. For use with PX4, PX4B and PXR4.

• Voltage: 4.5VDC
• Current: 500mA
• Tip positive; Sleeve negative

Sealed upper tension idler bearing for Leslies

Replace deteriorated rubber parts in Leslie cabinets. Includes grommets, o-rings, bushings, plug.