Jacks & Plugs

S-H700 Jack Plate - Plug and Play, Mono / Stereo
The Plug and Play eliminates the confusing switch found on most stereo cabinets. Just pick your impedance and plug in. Label is set at the common 4/16 Ohm Mono and 8 Ohm Stereo. Ready to install with a steel dish, wires, and speaker connectors.
$15.95
W-SC-11 Jack - Switchcraft, ¼", Mono 2-Conductor, open circuit
Switchcraft Type 11 Little-Jax phone jack. Mono 2-conductor, open circuit. Mates with standard ¼" plugs and is available with standard or long bushings. Great replacement for Fender® guitar & amp input jacks.
Starting at $1.95
W-SC-12A Jack - Switchcraft, ¼", Mono 2-Conductor, shunt tip
Switchcraft Type 12A Littel-Jax shorting type phone jack. The switched terminal is normally closed and is usually connected to ground to eliminate hum when unplugged. Mono 2-conductor. Mates with standard ¼" plugs and is available with standard or long bushings. Includes nut and washer
Starting at $2.15
S-H902-X Jack - Cliff, ¼", solder lugs, switched
Solder terminals, switched. Used in modern Marshall amps. Features: Low-noise Ni-Ag® Alloy Self-Cleaning Contacts for superior performance and reliability, tough, molded grade 1 black Nylon body.
Starting at $1.95
S-H800 Jack Plate - Marshall, Switchable Stereo / Mono
Switchable stereo/mono jack plate for back of cabinets.
$48.60
P-H180 Jack Plate - Single ¼", 2" Outside Diameter, Black Metal
  • Recessed steel cup
  • Designed for use with 1/4" jacks
  • Steel design
  • 3 mounting holes
$0.85
P-H150 Jack Cup - Marshall, for Input Jack On Speaker Cabs, Plastic
Plastic jack cup for input jack on speaker cabinets.
  • Diameter = 3 3/4''
  • Center to Center Screw Hole Spacing Distance = 2 1/8''
$7.15
S-H901-X Jack - Cliff, ¼", Solder Lug, for Marshall, metal nut
Solder terminals, switched. Metal ferrule, vintage style.
Features:
  • Low-noise Ni-Ag® Alloy Self-Cleaning Contacts for superior performance and reliability
  • Tough, molded grade 1 black Nylon body.
  • Made in the U.K.
  • Supplied with a metal hexagonal mounting nut
  • Designed to receive both mono and stereo 1/4" jack plugs

Withstand Voltage: 2000VDC Min. Maximum Current: 5A Temperature Rating: -10°C ~ +70°C Life (Minimum): 10,000+ Operations Nominal Contact Resistance: < 50 mΩ
Starting at $2.30
W-SC-12B Jack - Switchcraft, ¼", Stereo 3-Conductor, double open circuit
Switchcraft Type 12B Littel-Jax stereo phone jack. Mates with standard ¼" plugs and is available with 0.25" inside diameter bushing. Stereo 3-Conductor double open circuit (does not have switched terminal). Includes nut and washer.
$2.25
S-H507-A Jack - Stereo, ¼", PC Mount, for Fender® Amps '88 - '99
Fender® Style replacement ¼" stereo input jack that has 9 PCB mount terminals.
$1.75
S-H506-A Jack - Mono, ¼", PC Mount, for Fender® Amps '88 - '99
Fender® Style ¼" Mono Input Jack with 4 PCB Terminals.
$1.60
S-H903-X Jack - Cliff, ¼", PC Mount, switched
Input Jack. PC board terminals, switched. Used in modern Marshall amps, or as a replacement part for Marshall JCM 900 cabinets and more.
$1.95
S-H750-X Power Jack - DC Panel Mount
Colors Available:
½" panel mount with solder lugs. Round plastic with normally closed switch.
$0.95
W-SC-228-X Plug - Switchcraft, ¼", flat cable-mount, right-angle
Switchcraft ¼" Mono 2-conductor cable-mount plug. Flat shielded handle with solder terminals. Type 228. Used in Fender amps for speaker connections. Also perfect for close quarters pedal-to-pedal connections. Includes hardware
Starting at $4.95
S-H901-PC-X Jack - Cliff, ¼", PC Mount, for Marshall, metal nut
PC terminals, switched. Metal ferrule, vintage style.
Starting at $2.30
S-H514 Nut & Washer - Panel, for Fender / Marshall Jacks
Package of 5
M12 x1.0 thread. Package of 5.
$1.50
P-H190 Jack Plate - 1-Hole, Metal, Black, 4.02" x 4.40"
Generic, one hole jack plate with a smooth black finish. Perfect for use as a jack plate on speaker cabinets. The jack mounting hole has a diameter of 0.43" and fits Cliff jacks with external threads perfectly (see S-H902).
Center-To-Center mounting hole measurements are as follows:
  • Horizontal- 3-9/16”
  • Vertical- 3-3/16”
$3.25
S-H506 Jack - Fender®, ¼", PC Mount, Mono
Original 4-pin Fender jack. Fits Fender amplifiers from 1988 - 1999. PC mount. Fender part number: 099-0912-000
$4.95
S-H263 Binding Post - Dual, Gold-Plated
Dual, gold plated binding post.
  • Red and black posts
  • Accepts either single or dual banana plugs
  • Mounts in two ½" holes on ¾" centers, panel thickness up to ¼"
  • 15A rating
  • Gold plated contacts.
$3.85
W-SC-280-X Plug - Switchcraft, ¼", cable-mount
Switchcraft Type 280. ¼” straight plug with solder lugs and cable clamp. Switchcraft Heavy duty machined copper alloy handle, tip and body for unsurpassed ruggedness
Starting at $3.15
S-H267X RCA Jack - Chassis Mount, Front Mount, Gold Plated
Colors Available:
Gold, black/red/white band, front mount female RCA phono jack. Multiple color options available.
Starting at $2.50
W-SC-3501FR RCA Jack - Switchcraft, Rear panel-mount, natural-insulator
Switchcraft RCA/phono rear panel-mount jack. Natural insulator. Good replacement for Fender. Mounts in a 3/8" hole.
$2.39
W-SC-13 Jack - Switchcraft, ¼", Mono 2-Conductor, isolated make circuit
Switchcraft ¼" Mono 2-Conductor Input Jack, Isolated Make Circuit (Type 13). Includes nut and washer
$3.95
P-H191-B Jack Plate - 2-Hole, Metal, 3.5" x 5.13", Black
Generic, 2 hole jack plate with a smooth black finish or with a zinc chrome finish. Perfect for use as a jack plate on speaker cabinets. The jack mounting holes have a diameter of 0.43" and fit Cliff jacks with external threads perfectly (see S-H902). Center-To-Center mounting hole measurements are as follows:
  • Horizontal- 3-9/16”
  • Vertical- 2-15/16”
$3.25
Don't see what you're looking for? Send us your product suggestions!