Effect Pedals & Parts

Adding effects to your signal path is a great way to alter the sound of your guitar. Add reverb, delay, distortion, frequency ranges and other dynamic effects. Build a kit or purchase parts to make your own!
P-H-LEHLE-BTN-X Footswitch - Lehle, SPST, Momentary, Soft Click, Long Life
The LEHLE SWITCH BTN is a momentary foot switch. It is housed in an M12 threaded enclosure made of stainless steel. Thanks to the gold plated contact material its life span is at least one million switching cycles electrically and mechanically. Hardware included.
Starting at $14.95
P-ECB-126 Gear - Dunlop, replacement for Wah D-shaft pots
Original Dunlop replacement gear for wah potentiometers (C-ring included). The gear has 14 teeth and a flatted inner diameter to fit securely onto a potentiometer with flatted shaft. The included C-ring is placed over the top end of the gear to keep it from sliding off the end of the potentiometer shaft.
$1.95
P-ECB-24A Potentiometer - Dunlop Hot Potz, 470 kΩ
Used in Jimi Hendrix's WAH and Dunlop volume pedal. 470 kΩ. Original Dunlop replacement part.
$22.95
P-ECB-9V2 Battery Box - Gotoh, Dual, for 9 volt batteries
Dual 9 volt battery box. Two 9V battery compartments, each compartment having its own red and black wires for battery positive and negative connections (4 wires total) allowing for series, parallel or separate connections of two 9V batteries. Four wood screws included. Directions: 1. Refer to the Drawing B and make a hole on guitar body. 57.5 mm (2.26") x 49.5 mm (1.95"), R6 (6 mm = 0.24") 2. Put the box in guitar body and fix it by screws.
$19.00
P-H1590D Chassis Box - Hammond, Diecast Aluminum, 7.38" x 4.70" x 2.05"
  • Rugged, diecast aluminum alloy (tough yet easy to machine), electronic instrument enclosure.
  • Lap joint construction provides protection against access of dust and splashing water. Also provides for improved EMI/RFI shielding.
  • Vibra finished for a smooth surface with no sharp edges.
  • Six 6-32 x ½" machine screws secure lid - into tapped holes.
  • Designed to meet IP54.
  • Low side wall draft angle (2 degrees or less) for easy P.C.
$19.34
P-RBTDR-2V-X Reverb Module - Accutronics, Digi-Log, vertical mount, mini
A great digital reverb sound that easily replaces a spring reverberation unit. Stereo outputs may be summed for mono operation. Simple interface requires only input, output, +5V, and ground.
$14.95
P-H1590N1 Chassis Box - Hammond, Diecast Aluminum, 4.77" x 2.6" x 1.39"
Depending on the manufacturer, this enclosure is usually very similar to a 125B.
Aluminum enclosure with countersunk lid that machine screws into drilled and tapped holes. Lap joint construction provides protection from dust and water. Vibra finished, no sharp edges.
$10.81
P-H503 Footswitch - DPDT, Momentary, Solder Lugs
DPDT momentary footswitch. AC125V/4A AC250V/2A. Rated for 50,000 make-and-break cycles at full load.
$3.95
P-H503-PC Footswitch - DPDT, Momentary, PC Terminals
DPDT momentary footswitch with PC terminals. Black with 6 terminals. AC125V 4A, AC250V 2A. PC mount version of P-H503.
$4.50
P-ECB-152 Bottom Plate - Dunlop, for GCB-95 with Battery Door
Bottom Plate for GCB-95. Original Dunlop replacement part. Includes battery box, four mounting screws and four black rubber feet.
$13.95
P-ECB-GEAR Gear - replacement for Wah pedal potentiometer
Generic gear (a.k.a. pinion) for wah-style potentiometers. Outer diameter = 0.48", height = 0.61". Push-on for splined 1/4" shaft. Push-on mounting allows any 1/4" splined shaft potentiometer to be equipped for use with rack and pinion shaft rotation as in a wah pedal.
$1.50
M-PAS-CABLE-4 Cable - Power All, Blue Right Angle Phone Plug Extension Jumper
Included in the Power-All System and also sold separately, the Cable-Blue/R features a right-angle jack that allows users to power effect units that use a 1/8" (3.5 MM) phone plug connector with tip-positive polarity. The Cable-Blue/R can be connected to any male jack on the Cable-5 Daisy Chain, or directly to the PA-9 itself.
$3.00
P-H1590BBCE-PD Chassis Box - Diecast Aluminum, 4.67 x 3.68 x 1.18", predrilled
Same as Hammond P-H1590BB, but generic manufacture made in Taiwan. Measures 4.67" x 3.68" x 1.18" deep. Holes are drilled for pots, footswitch and jacks. Holes are 1 @ ½" dia., 2 @ 3/8" dia, and 2 @ 8 mm dia.
$9.95
M-PAS-S Power Supply - Power All System, 9V, 2000mA, for Effects Pedals
The PA-9 Power-All is the world's first 2000 mA, single outlet power supply designed specifically for guitar effect users. Don't waste money on batteries or take up valuable space with multiple "wall wart" adaptors or power bricks - the Power-All system can power your entire pedalboard from a single power supply that takes up only one outlet! The Power-All's special circuit design offers the lowest noise floor of any digital power supply on the market. The PA-9S now comes with a ferrite-core filter built onto its output cable to further reduce noise and hum.
$19.95
P-RBTDR-1H-X Reverb Module - Accutronics Belton, Digi-Log, horizontal mount
A great digital reverb sound that easily replaces a spring reverberation unit. Simple interface requires only input, output, +5V, and ground. Output requires no external capacitors.
Starting at $12.95
R-VPC01 Photocell - Morley, for Effects Pedals
Photocell for Morley effects pedals. Great replacement for LDR1, LDR2 and LDR3 (M79-211564-000) in Morley Pro Series Volume PVO. Sold individually.
A photocell may also be referred to as a photoresistor, LDR, or light dependant resistor.
$2.50
M-PAS-CABLE-3 Cable - Power All, Black Right Angle Extension Jumper
Included in the Power-All System and also sold separately, the Cable-Black/R allows the user to power over-sized effect units or units w/AC jacks in hard-to-reach places off of the Power-All Daisy Chain. The Cable-Black can be connected to any plug on any Power-All daisy chain, or directly to the PA-9 itself.
$3.00
P-H-LEHLE-SW-X Relay Module - Lehle, Relay True Bypass Switching Unit
The LEHLE MODULE SW is a true bypass switching unit with relay and an active pop suppression function controlled by an intelligent microcontroller circuit, thereby allowing the LEHLE MODULE SW to switch even faster than mechanical switches, noise-free and without wear.
Starting at $22.95
R-VWAH-LP Potentiometer - 100kΩ, Wah Replacement, Life, Smooth
100K Life Pot is a high grade Wah pot replacement. This wah pedal upgrade is sold with all necessary hardware and gear for immediate installation.
$11.95
P-R-ABE DSP Module - ABE, Accu-Bell Effector, 3 Adjustable Effects
The Accu-Bell Effector offers reverb, chorus, and delay with adjustable setting and tap tempo. This module runs on 5.5V to 9.5V DC so it is easy to incorporate into effect pedal builds. Please see the attached datasheet for an example schematic.
$21.95
R-V1MJ-SS Potentiometer - Fender, 1MΩ, J Taper, Solid Shaft, Panel Mount
Pot, Solid Shaft, 1M J Taper
$7.50
P-ECB-233 Switch - Dunlop, PCB mount, boost / distortion kick switch
ECB233 boost / distortion kick switch. Original Dunlop replacement part. Used in the SW95 Crybaby Slash Wah. Through hole PCB mount.
$4.50
P-GRIP-1 Pedal Tape - Godlyke, Power Grip, 1 Meter Roll
For the best Pedalboard Dual Lock and Velcro Alternative, try Power-All Power-Grip. Simple, yet ingenious, Power-Grip pedal board tape mates to itself via rows of tiny mushroom-shaped posts that form a much stronger bond than traditional "hook & loop" Velcro fasteners. Just cut to size, apply, and GRIP! Approximately enough for 6 standard-sized pedals
$14.95
P-ECB-555 Switch - Dunlop, Footswitch, DPDT, Solder Lugs, for MXR
Dunlop® Electronic Components DPDT latching footswitch with solder lugs for MXR, Cry Baby, and other effects pedals.
$14.95
Don't see what you're looking for? Send us your product suggestions!