Effect Pedals & Parts

Adding effects to your signal path is a great way to alter the sound of your guitar. Add reverb, delay, distortion, frequency ranges and other dynamic effects. Build a kit or purchase parts to make your own!

Effect Pedals & Parts

Adding effects to your signal path is a great way to alter the sound of your guitar. Add reverb, delay, distortion, frequency ranges and other dynamic effects. Build a kit or purchase parts to make your own!
P-H16-150 Bumper - Morley, tapered rubber feet, self adhesive
Package of 20
Small tapered rubber feet with self-adhesive backing (package of 20). Can be used to provide grip and slight elevation (about 0.14") when secured to most project enclosures. Great for effects pedals and rack mount units when removed from the rack.
$4.45
Save 11%
Originally: $5.00
P-H511 Switch - Replacement for Boss Effects Pedals
Replacement for Boss effects pedals, SPST momentary, push switch. Mounts in square hole approximately. 55" x.55" x 1.08" overall length including terminals.
$2.23
Save 11%
Originally: $2.50
K-950 Effects Pedal Kit - MOD® Kits, The Thunderdrive, Overdrive
The Thunderdrive is an overdrive pedal kit that will provide a signal boost at low gain settings and its own distortion at maximum gain settings. You can use it to push your preamp into overdrive or as a source of smooth distortion. Adjusting volume control and gain control results in a wide variety of tones in spite of its simple construction. This pedal is capable of overdriving the preamp section of your guitar amp or adding its own layer of distortion at lower volume. Using point to point wiring and easy to follow instructions you can have a working overdrive pedal in a matter of hours. All you need to provide is solder and a soldering iron. Uses 9 volt battery which is not included.
$26.66
Save 11%
Originally: $29.95
K-920 Effects Pedal Kit - MOD® Kits, The Piledriver, Power Boost
"The Piledriver" is a clean-boost kit that will provide up to 38dB of gain to your guitar signal. Use it to push your preamp into overdrive or as a line driver if you are experiencing signal degradation from your effects chain. This is a simple kit and great for beginners!
$24.88
Save 11%
Originally: $27.95
P-ECB-24B Potentiometer - Dunlop, Hot Potz II Crybaby, 100 kΩ
Hot Potz II Crybaby Pot. for newer Crybaby models. Made by Beckman. 100 kΩ. Original Dunlop replacement part. The same tone and sweep characteristics as the original Cry Baby Hot Potz potentiometer with low wiper noise and extended life.
$18.33
Save 11%
Originally: $20.59
K-955 Effects Pedal Kit - MOD® Kits, The Thunderdrive Deluxe, Overdrive
The Thunderdrive Deluxe LTD is an overdrive pedal kit that will provide a strong, clean signal boost in the early gain settings and smooth distortion at maximum gain settings. Adjusting "Output" and "Distortion" controls provides a wide variety of tones in spite of its simple construction. It is capable of overdriving the pre-amp section of your guitar amp or adding its own layer of distortion at lower volume. This version is equipped with a three-position diode-selector switch.
The switch offers three different settings and tones. The top position is the classic silicon clipping diodes used in the original Thunderdrive. The middle position gives you the lifted diode "turbo" sound from the Deluxe model. The bottom position is a new setting limited to this version using germanium diodes for a warm vintage distortion.
This is an easy build kit with point to point wiring and clear, easy to follow instructions.
$35.56
Save 11%
Originally: $39.95
K-930 Effects Pedal Kit - MOD® Kits, The Persuader, Tube Drive
Build your own tube preamp pedal built around a 12AX7 tube. Go from clean, warm tone to smooth, real tube overdrive. This kit includes pre-drilled die-cast aluminum enclosure and all parts with easy to follow instructions. All you need to provide is solder and soldering iron. The Persuader allows for easy access to the tube, giving you the ability to quickly experiment with different tube brands and 12AX7 tube relatives. Operates on a 9V battery or AC adapter, which is not included. When completed, this pedal draws considerable current and battery life will be short. The Godlyke 9-volt adapter (M-PAS-S) may be purchased separately to power your new pedal.
$60.48
Save 11%
Originally: $67.95
P-H501 Switch - Footswitch, 3PDT, Blue, Taiwan
Good stomp-box effects switch (Triple Pole, Double Throw). 3PDT Latching type footswitch. Made in Taiwan.
$6.19
Save 11%
Originally: $6.95
P-H492 Switch - Carling, Footswitch, SPDT
Carling SPDT footswitch used in footswitch boxes and effects pedals (112-P).
$6.19
Save 11%
Originally: $6.95
K-970 Effects Pedal Kit - MOD® Kits, The Tea Philter, T Filter
The Tea Philter - A T-Filter Pedal Kit The Tea Philter pedal produces a fixed wah tone allowing you to lock it in without rocking the pedal back and forth. Every guitar/wah combination has a certain sweet spot that is perfect for lead and chord work. The Tea Philter lets you dial in everything from your favorite vocal mid-range tone to thick lows. Using point-to-point wiring and easy-to-follow instructions you can have a working fixed wah pedal in a matter of hours. The effect pedal operates on a 9V battery. For a longer lasting option, a 9-volt adapter can be purchased separately.
$28.44
Save 11%
Originally: $31.95
P-H493 Switch - Carling, Footswitch, SPST, for Fender® & Others
Carling SPST footswitch. Used in Fender etc. Reverb/tremolo/channel switching pedals, (110-P).
$5.30
Save 11%
Originally: $5.95
P-H497 Switch - Carling, Footswitch, DPDT, On-On, Side Solder Lugs
Good stomp-box effects switch (Double Pole, Double Throw), On-On. Solder Lugs. 1A 250V, 3A 125V
Note: On-On switches may sometimes be referred to as On-None-On.
$7.08
Save 11%
Originally: $7.95
K-980 Effects Pedal Kit - MOD® Kits, The Persuader Deluxe, Overdrive
The Persuader Deluxe utilizes a Darlington preamp to push cascaded triode vacuum tubes into distortion. Four dual triode vacuum tubes are included with each kit (JJ 5751, 12AX7B China, JJ 12AU7 and a NOS USA-made 12AT7). Swap to create a wide range of tones from just a hint of break up from the JJ 5751 to over the top crunchy distortion using the NOS US made 12AT7. A boost switch provides an additional layer of flexibility with added gain and a little extra bottom end. An LED indicator lights up when the Persuader Deluxe is engaged and not in true bypass mode. Operates on a 9V battery or AC adapter, which is not included. When completed, this pedal draws considerable current and battery life will be short. The Godlyke 9-volt adapter (M-PAS-S) may be purchased separately to power your new pedal.
$88.96
Save 11%
Originally: $99.95
S-H155 Battery Clip - 9 Volt
Package of 3
9 volt battery clip with 5 3/4" red and black wire lengths. Simple construction and perfect for use in effects pedals. Package of three.
$0.53
Save 12%
Originally: $0.60
S-H750-X Power Jack - DC Panel Mount
Colors Available:
½" panel mount with solder lugs. Round plastic with normally closed switch.
$0.85
Save 11%
Originally: $0.95
K-960 Effects Pedal Kit - MOD® Kits, The Trill Tremolo
The Trill Tremolo pedal offers classic tremolo tones in an easy to build kit. The Trill's speed knob provides a wide range from a very slow to rapid fire effect. The depth knob varies the ratio between effected and dry signal. Using modern, low noise transistors makes operation of The Trill quiet with no signal drop when engaged. The Trill uses true bypass foot switching so it is out of the signal path when not engaged. All you need to provide is solder and tools! Uses 9 volt battery which is not included.
$41.79
Save 11%
Originally: $46.95
P-RBTDR-2H-X Reverb Module - Accutronics Belton, Digi-Log, horizontal, mini
A great digital reverb sound that easily replaces a spring reverberation unit. Small package is half the size of the P-RBTDR-1H-X
$13.31
Save 11%
Originally: $14.95
P-ECB-151 Rubber feet - Dunlop, for Crybaby, includes screws
Package of 4
Rubber feet with screws for Dunlop Crybaby Wah pedal. Package of four. Original Dunlop replacement part. Rubber foot diameter: 5/8" Rubber foot height: 5/16" Screw threading: #6-32 (screw extends 5/16" beyond the rubber surface)
$2.31
Save 11%
Originally: $2.60
P-H498 Switch - Footswitch, DPDT
Great replacement for stomp-box effects requiring a DPDT (Double Pole, Double Throw) switch. AC125V/4A AC250V/2A.
$3.52
Save 11%
Originally: $3.95
P-L300X LED - 3mm diameter, diffused lens
Package of 5
Colors Available:
Lens Diameter: 3 mm Overall Height: 5.4 mm Lens Type: Diffused Multiple color options available.
$0.58
Save 11%
Originally: $0.65
P-RBTDR-3H Reverb Module - Accutronics Belton, Digi-Log, Adjustable Decay
A great digital reverb sound that easily replaces a spring reverberation unit. Stereo outputs may be summed for mono operation. Simple interface: input, output, +5V, and ground
$14.20
Save 11%
Originally: $15.95
K-965 Effects Pedal Kit - MOD® Kits, The Contortionist II, Fuzz
The Contortionist II kit is an all analog, high octane fuzz box. It produces fuzz with layered octave overtones similar to those produced by an electronic-bow. The frequency multiplier circuitry creates harmonics that swell and recede depending on gain setting, pick attack, neck position and pickup. This is a high gain circuit that can put out up to 2 volts and will provide ample amounts of sustain. The Contortionist II has all the features of the original Contortionist with an added tone control for a wider range of sounds, and an LED that lights up when the unit is activated.
$42.68
Save 11%
Originally: $47.95
P-ECB-035 Switch - Dunlop, Footswitch, GCB-95
GCB-95 switch. This is a large double pole double throw (DPDT) effect/bypass switch for MXR and Cry Baby pedals, featuring the Dunlop “D” logo.
$8.86
Save 11%
Originally: $9.95
P-K345 Knob - Black, Line, Set Screw, 1.0" diameter x .6" tall
1.0" diameter x.6" tall, black with white line and brass insert, set screw. Similar to Dunlop knob.
$1.16
Save 11%
Originally: $1.30
Don't see what you're looking for? Send us your product suggestions!