Cables

Self adhesive metal cable clips. They easily attach to most surfaces using a strong foam adhesive. These cable clips are a great way to tidy up project wiring and securing components.

Durable heavy duty nylon cable ties. These zip ties are a great way to tidy up project wiring and securing components. Features

• Approved for outdoor use.
• UL Listed 6.6 nylon.
• Locks tightly - Won’t stretch or slide.
• Temperature range from 40° to 180°F.
• 8 inch length
• 40 lb tensile strength

Easy to use cable tie gun cuts ties up to 50 lb. tensile. Use this tool to pull ties tightly and then cut the excess length.

Nylon cable clamp with room for 1/4” cable outer diameter. Perfect for securing cables to cabinet walls. For larger ½” cable clamps see P-HCABLECLAMP-10.

ProCo StageMaster low-impedance microphone cables are designed to be quiet, durable and dependable. These cables are hand-soldered with top-quality metal XLR connectors and extremely low-noise, twisted-pair wire.

• Quiet and Durable CS-MIC.K 2-conductor Shielded Audio Cable
• Terminated with High Quality Nickel Plated XLR Connectors for Years of Superior Performance and Maximum Value
• Individually Tested to Meet Performance and Quality Requirements

Low cost, high quality 3.5mm patch cables in a variety of lengths and colors. The cables are super flexible, have a great droop, and are shipped coiled so no permanent kinks are formed. With the large selection of lengths and colors, these cables are the perfect choice for any sized system.

Right angle RCA cables for Reverb Tanks and other electronic devices.

Durable nylon cable ties. These zip ties are a great way to tidy up project wiring and securing components. Features

• Approved for outdoor use.
• UL Listed 6.6 nylon.
• Locks tightly - Won’t stretch or slide.
• Temperature range from 40° to 180°F.

20 AWG double shielded, stranded (27x34) high-conductivity TC conductor, EPDM rubber insulation, conductive textile (100%) plus TC spiral shields (95% coverage), paper tape, CPE jacket. 105°C temperature rating, 600V.

A 6.5mm noiseless cable equipped ¼" straight molded phone plug ends. Specifically designed cables prevent shocks and allows for minimum hum or noise. Provides 100% signal!
Braided Fabric Covered Cable with Gold Plated Plugs

Connector - for Accutronics Blue reverb tanks P-RAMC2BF2 and P-RAMC2BF3. One green and one red per item.

A 6.5mm 2P braided microphone cable. Specifically designed to prevent shocks and allows for minimum hum or noise. Provides 100% signal!
Braided XLR Female to 1/4" phone plug, High Z

Designed for larger pedalboards, the Power-All Cable-11/R Daisy Chain features ELEVEN right-angle male barrel plugs with spring loaded jacks for extra secure connections – no more losing power mid-solo! 28-gauge cable with oil-resistant sheath and 10-inch cable length between plugs allows connection of larger and odd-sized pedals.

Make your own cable. Excellines 20 AWG 26 strand guitar cable. Sold per foot

Included in the PA-9ECD Deluxe Kit and also sold separately, the Cable-Blue/R features a right-angle jack that allows users to power effect units that use a ⅛" (3.5 MM) phone plug connector with tip-positive polarity. The Cable-Blue/R can be connected to any male jack on the Cable-5 Daisy Chain, or directly to the ECO-Dapter® itself.

ProCo cable is the world renown industry standard. The excellines cable are the musician's choice when it comes to guitar cable made with G&H ¼" BigFoot straight phone plug to ¼" Bigfoot right angle phone plug.

Included in the PA-9ECB Basic Kit and also sold separately, the Cable-Grey allows the user to power vintage and boutique effect units that run off 9-volt batteries but do not have an external AC power jack. The Cable-Grey hooks directly to the unit's Battery Snap and can be connected to any of the Power-All daisy chains, or directly to the Power-All.

Make your own cable. Excellines 16AWG two conductor non-shielded cable is sold by the foot.

The Fender® Original Series raises the bar for quality and reliability with their coiled cables. This cable uses a 23 gauge 99.95% oxygen free copper conductor with a 90% shield and a classic Fender® color for the insulation. These hand soldered cables use nickel plated ¼” connectors with a right angle and one straight plug.

24AWG StageMASTER Instrument Cables are designed to be quiet, durable and dependable. They are hand-soldered to perfection using top quality metal ¼" connectors and extremely low-noise cable.

Made in USA instrument cable with a 0.195” outer diameter. This high quality cable is perfect for pedal boards patch cables and also works great for standard instrument cables.

• 20AWG stranded bare copper conductor
• Polyethylene insulation covered by a sheet of conductive vinyl
• Copper braid shield
• PVC outer jacket

ProCo StageMaster cables are designed to be quiet, durable and dependable. Constructed from high quality materials and built to withstand everyday use. They are hand-soldered to perfection using top quality metal 1/4” connectors and extremely low-noise cable.

Nylon cable clamps perfect for securing cables to cabinet walls. These clamps feature a .203 in. mounting hole. The ⅜ in. diameter cable clamp is commonly used on Fender® amplifiers for securing the power cord. SKU Diameter P-HCABLECLAMP-38 ⅜ in. P-HCABLECLAMP-12 ½ in.

Fully Assembled version: Package includes two vintage style RCA cables: One 3 foot and one 5 foot.
DIY Kit: Assembly required. Kit comes with one 3 ft. and one 5 ft. length of insulated braided wire and 4 RCA plugs. Solder RCA plugs onto the ends of the wires by stripping 3/8" of the white insulation from wire. Insert wire into tip. Solder in place. Next, solder braided shielding to sleeve of the plug.