Amplifier Parts

For 35/64" x 5/8" chassis hole, 11/32" cord diameter. Fits most Fender® amps.

• Protects the lifeline of your electric/ electronic products by absorbing the forces of pull, push, and twist that may be exerted on the flexible power cord.
• Securely anchors, insulates, and protects cables at panel entry points

Phillips panhead machine screw, 4-40, zinc. Designed to go through a hole or nut that is pre-tapped to form a mating thread for the screw. Has a general purpose bearing area and can be substituted in most applications for round, truss, or binding heads. Phillips drive is the most common drive used and is designed to "camout" when the screw reaches optimum tightness, thus preventing damage to the screw head.

Steel, type A narrow. SAE washers have a tighter fit on the bolt and a smaller outside diameter. Designed for general purpose mechanical and structural use.

Through-hole PCB mounted fuse holder clips found in Peavey amps and other electronics. These small clips allow for minimal space fuse mourning directly on PCB’s. Fits GMA 5×20mm fuses. A pair is required to mount a fuse. Sold individually.

Black oxide finished steel lock washers that use internal teeth for locking and tension. The internal teeth dig into the screw head or nut while the smooth outside edge won't snag objects. These washers provide greater vibration resistance than split lock washers. Black oxide lock washers like these can be found in vintage Marshall amplifiers. Pairs nicely with S-HSB4-X, S-HSB6-X, and S-HSB8-12 screws and S-HBNX nuts.

Steel 20mm screw nails for corners, logos, badges, and more. These screw nails make adding cabinet accessories easy requiring only a mallet for installation. The design is great for speaker cabinets ensuring a better grip than standard nails and tacks under extreme vibrations.

Zinc nut. Designed to be used with any low carbon bolt or screw such as a grade 2 bolt. Most commonly used nut. Achieves strength through cold forming. Low carbon steel.

0.125" diameter nickel plated brass contact pin. Fits .062" and .093" boards. Height is .566" when mounted. In addition to turret board use, these pin connectors are often found on printed circuit boards. They are referred to as through hole terminal pins, header pins, or crimp contact pins.