You are here

Accessories

Filter these results
Sort By:
products per page
View Mode: List View · Grid View

Pages

(9 pages)
K-998Effects Pedal Kit - MOD® Kits, Tone Attack, Active Tone Stack

Shape your sound with the Tone Attack. 12 o'clock settings give an approximate unity gain with the pedal. Rotate the treble or bass knob counterclockwise to cut the corresponding frequencies. Rotate these same knobs clockwise to boost the frequency bands. The master boost knob can be used to attenuate your signal or push your tone to screaming loud volumes. MOD® Kits are designed to give both novice and experienced musicians the opportunity to build their own amps and effects pedals. All kits come with easy to follow instructions and use point to point wiring. Pre-drilled enclosure and all parts are included. All you need to provide are hand tools, a soldering iron and solder. The Tone Attack operates on a 9V battery or AC adapter, which is not included. The Godlyke 9-volt adapter (M-PAS-S) may be purchased separately to power your new pedal.


$64.95
$51.96
You save: 20%
Click to read more
K-997Effects Pedal Kit - MOD® Kits, Erratic Clutch Deluxe, Fuzz/Divider

The Erratic Clutch Deluxe is a unique effect pedal kit that gives you fuzzy square wave distortion as well as a monophonic sub-octave square wave using a total of only four transistors. The two signals can be used individually or mixed together for a raw and sonically rich synthy output. Full of character and quirk, this pedal will give you a truly original sound. The middle knob is the bias control. This adjusts the pulse width in the initial fuzz stage of the pedal. Set this knob to fit your pickups and playing style. The closer to the center the longer the note will sustain but with that comes more chaotic tracking for the divider. Moving it more clockwise or counterclockwise will give you more predictable note tracking on the divider with less sustain.


$69.95
$55.96
You save: 20%
Click to read more
K-996Effects Pedal Kit - MOD® Kits, The Penetrator, Treble Boost

The Penetrator is a treble boost pedal kit with enough gain to cut straight through any mix. This pedal adds glistening harmonics that get loud enough to saturate your amp’s front end. Adjust the level knob to vary the output so there’s no mistaking when you kick this pedal in. Great for solos or when you need your guitar front and center.


$38.95
$31.16
You save: 20%
Click to read more
K-991Effects Pedal Kit - MOD® Kits, The Rock Bottom, Bass Fuzz

The Rock Bottom is a bass fuzz kit that gives you all of the sizzle you'd expect from a vintage fuzz without sacrificing those low frequencies. Use the blend pot to set your fuzz levels and dial in the volume to get that sound you need. This versatile pedal can be used for the sludgiest bass tones to the cleanest boost and everything in-between.


$43.95
$35.16
You save: 20%
Click to read more
P-GRIP-1Pedal Tape - Godlyke, Power Grip, 1 Meter Roll
For the best Pedalboard Dual Lock and Velcro Alternative, try Power-All Power-Grip. Simple, yet ingenious, Power-Grip pedal board tape mates to itself via rows of tiny mushroom-shaped posts that form a much stronger bond than traditional "hook & loop" Velcro fasteners. Just cut to size, apply, and GRIP!
$14.95
$11.95
You save: 20%
Click to read more
M-PAS-CABLE-7Cable - For Power All Systems, C-R/R
Included in the Power-All System and also available separately, the Cable-Red/R allows the user to power effect units that have reverse polarity barrel connectors (tip positive/barrel negative). The Cable-Red/R features a tip positive, male barrel connector that is spring-loaded to prevent disconnection.
The Cable-Red/R can be hooked to any plug on any of the Power-All daisy chains, or directly to the Power-All.
Length: Cable-Red/R is 140 mm (approximately 5.5 inches) in length from plug to plug.
Whether you’re using the Power-All digital Power Supply or another manufacturers’ multi-output power brick, Power-All cables are the best way to assure that your pedals are getting the power they need - when and where they need it.
$3.00
Click to read more
M-PAS-CABLE-6Cable - For Power All Systems, C-GY
Included in the PA-9 Power-All System and also sold separately, the Cable-Grey allows the user to power vintage and boutique effect units that run off 9-volt batteries but do not have an external AC power jack.
The Cable-Grey hooks directly to the unit's Battery Snap and can be connected to any of the Power-All daisy chains, or directly to the Power-All.
Cable-Grey is 158.75 mm (approximately 5.25 inches) in length from plug to plug.
NOTE: The Power-All Cable-Grey was designed to hook directly to the battery snap inside a pedal and then provide power to the pedal using an external DC power adaptor.
The wiring of the Cable-Grey’s battery snap is the OPPOSITE of what would normally be needed to connect to a 9-Volt battery.
$3.00
$2.40
You save: 20%
Click to read more
M-PAS-CABLE-5Cable - For Power All Systems, C-GN/R
Included in the Power-All system and also sold separately, the Cable-Green Right Angle jumper allows the user to power Line-6 Stomp-Box modelers and other digital effect units from the PA-9. The Cable-Green features a reverse-polarity (tip positive), right-angle male barrel connector with a larger, 2.5 mm internal diameter and spring-loaded clips.
The Cable-Green/R can be used with Line-6 Modelers, Electro-Harmonix units, and other pedals requiring a larger internal diameter plug.
$3.00
Click to read more
M-PAS-CABLE-4Cable - For Power All Systems, C-BL/R
Included in the Power-All System and also sold separately, the Cable-Blue/R features a right-angle jack that allows users to power effect units that use a 1/8" (3.5 MM) phone plug connector with tip-positive polarity. The Cable-Blue/R can be connected to any male jack on the Cable-5 Daisy Chain, or directly to the PA-9 itself.
Note: to achieve tip-negative polarity from the Cable-Blue/R, simply attach a Cable-Red (M-PAS-CABLE-7) in between it and the power source.
Plug: Right-Angle Configuration with 3.5 mm (1/8") W x 15 mm L Phone plug.
Length: 130 mm (approximately 5.25 inches) between plugs
Whether you’re using the Power-All digital Power Supply or another manufacturers’ multi-output power brick, Power-All cables are the best way to assure that your pedals are getting the power they need - when and where they need it.
$3.00
Click to read more
M-PAS-CABLE-3Cable - For Power All Systems, C-BK/R
Included in the Power-All System and also sold separately, the Cable-Black/R allows the user to power over-sized effect units or units w/AC jacks in hard-to-reach places off of the Power-All Daisy Chain. The Cable-Black can be connected to any plug on any Power-All daisy chain, or directly to the PA-9 itself.
Plug: 5.5 mm W x 10 mm L with 2.1 mm internal diameter and spring-loaded plug.
Length: 267 mm (approximately 10.5 inches) between plugs.
Whether you’re using the Power-All digital Power Supply or another manufacturers’ multi-output power brick, Power-All cables are the best way to assure that your pedals are getting the power they need - when and where they need it.
$3.00
Click to read more

Pages

(9 pages)
Don't see a product you're looking for? Send us your product suggestions!
Subscribe to RSS - Accessories